We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Unity 15334 rear right strut assembly silver metal coil spring top mount 25 x 9 x 9 inch 19 lbs

Unity

Unity 15334 Rear Right Complete Strut Assembly 2004-2007 Subaru Impreza Sedan

SKU CH-WZQJ-6C9V9

Preassembled rear right strut restores factory ride height on 2004-2007 Impreza sedans with all new components included

  • TypeInstallation Tools
  • Restores factory ride height with OE-style precision
  • Preassembled unit includes mount, bearing, bumper, insulators and spring
  • All-new components remove the need for specialty tools
  • Lowers vehicle approximately 1.4 inches for a premium feel
  • Fits 2004-2007 Subaru Impreza sedan rear right only

Rear Right Strut Assembly for 2004-2007 Impreza

This new Unity 15334 complete strut assembly fits the rear right corner of 2004 to 2007 Subaru Impreza sedan models. It arrives fully preassembled with a gas-charged cartridge, coil spring, top mount, bearing plate, bumper and insulators. The unit weighs 19 lbs and measures 25 x 9 x 9 inches for direct installation.

Replaces Worn Rear Right Strut on Sedan Models

The assembly restores factory ride height and eliminates the need for specialty tools or spring compressors during installation. All components are new, including bearing plates, upper and lower spring isolators and a rubber dust boot. The supplier notes that replacing both rear sides together yields the best results for balanced handling.

Preassembled Unit Simplifies Sustained Repair Work

Because every part is factory assembled, the repair avoids the safety risks and time loss of compressing and decompressing coil springs on the job. The gas-charged shock cartridge is designed to maintain consistent damping through repeated cycles. This kit fits sedan models only and is not intended for wagon or hatchback variants.

Highlights

  • Restores factory ride height with OE-style precision
  • Preassembled unit includes mount, bearing, bumper, insulators and spring
  • All-new components remove the need for specialty tools
  • Lowers vehicle approximately 1.4 inches for a premium feel
  • Fits 2004-2007 Subaru Impreza sedan rear right only

Specifications

TypeInstallation Tools

Questions about this item

Will the 15334 strut assembly bolt directly to the stock mounting points on my 2004-2007 Impreza sedan without modification?

Yes, it is an original-equipment style complete strut assembly precision designed for a direct fit on 2004-2007 Subaru Impreza sedan models.

Do I need a spring compressor or other specialty tools to install this pre-assembled unit?

No, the assembly arrives fully pre-assembled with top mount, bearing plate, bumper, insulators and coil spring, eliminating the need for specialty tools.

Which components in this 19 lb assembly are most likely to need replacement after extended use?

The gas-charged shock cartridge and rubber dust boot are wear items that typically require replacement before the coil spring or metal mounts.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.