We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Silver rear left strut assembly with coil spring and top mount, new condition

Unity

Unity 15073 Rear Left Complete Strut Assembly 2012-2017 Toyota Camry SE

SKU CH-EH3S-04HN9

Preassembled rear-left strut restores factory ride height on 2012-2017 Toyota Camry SE models

  • TypeInstallation Tools
  • Original equipment style restores factory ride height
  • Preassembled with top mount bearing plate bumper insulators coil spring
  • Hassle free repair eliminates need for specialty tools
  • Replace both sides for best results
  • Fits 2012 2017 Toyota Camry SE only

Unity 15073 Rear Left Strut Assembly

The Unity 15073 is a complete rear left strut assembly built for the 2012-2017 Toyota Camry SE. It arrives fully preassembled with a new coil spring, gas-charged shock cartridge, top mount, bearing plate, bumpers and insulators. The unit restores factory ride height and handling without requiring a spring compressor or specialty tools during installation.

Replaces Worn Rear Left Strut On Camry SE

This assembly replaces a leaking, noisy or sagging original strut on the driver-side rear corner of the SE trim. The jump is worth it when the existing unit shows fluid loss, excessive bounce or uneven tyre wear that alignment cannot correct. Replacing both rear struts together is recommended to maintain balanced damping and consistent ride height across the axle.

Direct-Fit Design Limited To SE Trim Only

The strut is engineered specifically for the SE suspension tune and will not fit base, LE, XLE or hybrid models from the same years. Buyers who need a front strut, a right-rear unit or a complete kit for a different trim must select a separate part number. The preassembled format eliminates spring-compression hazards but offers no adjustment for ride height or damping rate.

Highlights

  • Original equipment style restores factory ride height
  • Preassembled with top mount bearing plate bumper insulators coil spring
  • Hassle free repair eliminates need for specialty tools
  • Replace both sides for best results
  • Fits 2012 2017 Toyota Camry SE only

Specifications

TypeInstallation Tools

Questions about this item

What are the boxed dimensions of the Unity 15073 rear left strut assembly?

The assembly ships in a box measuring 25 x 9 x 9 inches and weighs 18 lbs, so verify trunk or hatch clearance before ordering.

Which step is most often missed when installing this preassembled strut on a 2012-2017 Camry SE?

Torque the top mount nuts to the factory specification after the vehicle weight is on the suspension; skipping this causes premature bearing noise.

When should the gas-charged cartridge inside this Unity 15073 assembly be replaced?

The cartridge is sealed for life; replace the entire strut assembly if damping fades, fluid leaks, or ride height drops below factory spec.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.