We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Unity 13030 front complete strut assembly for 2002-2005 Mitsubishi Lancer ES

Unity

Unity 13030 Front Complete Strut Assembly

SKU CH-P9B9-ZQ05D

Pre-assembled front strut assembly fits 2002-2005 Mitsubishi Lancer ES models for simplified suspension repair

  • Ready-to-install strut assembly saves repair time
  • Preassembled with mount, bearing, bumper and spring
  • Unity’s 50 years of aftermarket suspension experience
  • Fits 2002-2005 Mitsubishi Lancer ES models
  • All-new components eliminate need for specialty tools

Ready-to-install front strut assembly

Unity 13030 front complete strut assemblies arrive preassembled with top mount, bearing plate, bumper, insulators and coil spring. They replace the entire strut unit on 2002-2005 Mitsubishi Lancer ES models without requiring specialty tools. The design targets DIYers and shops that want a single-box repair.

Replaces worn original struts on ES trim

The assembly swaps out factory units that have lost damping or suffered spring sag after years of service. The jump is worth it when the original struts are leaking, noisy or causing uneven tyre wear and you want all-new components in one step. It is not for non-ES Lancer trims or other Mitsubishi models.

Bolt-in installation with common hand tools

Because every component is preassembled, the job avoids spring compressors and the risk of misaligned mounts. Common pitfalls include reusing old mounting hardware, skipping the specified torque sequence and forgetting to recheck alignment after the repair.

Highlights

  • Ready-to-install strut assembly saves repair time
  • Preassembled with mount, bearing, bumper and spring
  • Unity’s 50 years of aftermarket suspension experience
  • Fits 2002-2005 Mitsubishi Lancer ES models
  • All-new components eliminate need for specialty tools

Specifications

BrandUNITY

Questions about this item

Will the 13030 strut assembly bolt directly to the factory mounting points on a 2002-2005 Mitsubishi Lancer ES?

Yes, the Unity 13030 is engineered as a direct replacement for the original front struts on 2002-2005 Mitsubishi Lancer ES models and uses the factory mounting locations.

Do I need a spring compressor to install this complete strut assembly?

No, the assembly arrives pre-assembled with the coil spring, top mount, bearing plate, bumper and insulators installed, so a spring compressor is not required for installation.

Are the upper strut mount and bearing plate included, or will I need to reuse the originals?

The 13030 assembly includes new top mount, bearing plate, bumper and insulators, so the original upper hardware does not need to be reused.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.