We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Unity 11265 front left complete strut assembly for 2014 Ford F-150 4WD

Unity

Unity 11265 Front Left Complete Strut Assembly 2014 Ford F-150 4WD

SKU CH-Z5TX-Y2RD3

Pre-assembled front left strut with mount, bearing, spring and insulators for 2014 Ford F-150 4WD models

  • Complete strut assembly simplifies installation
  • Pre-assembled with mount, spring and insulators
  • Fits 2014 Ford F-150 4WD models
  • 50 years aftermarket manufacturing experience
  • Unity part number 11265 ensures correct fit

Front Left Complete Strut Assembly for 2014 Ford

This Unity 11265 assembly is a direct-fit replacement for the front left corner of 2014 Ford F-150 four-wheel-drive models. It arrives fully preassembled with the top mount, bearing plate, bumper, insulators, and coil spring included. The design eliminates the need for specialty spring compressors during installation. Professional technicians and experienced DIYers can complete the repair in a single step.

Preassembled unit with integrated coil spring

The complete strut ships as a single unit, so no separate components must be sourced or assembled on the bench. Unity manufactures each piece to match original equipment dimensions for proper ride height and alignment geometry. The integrated bearing plate and insulators are engineered to reduce road noise transmitted into the cabin. Installation follows standard service procedures without additional tooling.

Tested for long-term durability on 4WD platforms

Unity applies over 50 years of aftermarket suspension experience to validate the assembly under repeated compression and rebound cycles. The coil spring rate and damper calibration are tuned for the weight distribution of 4WD variants. Components are built to resist corrosion and fatigue through seasonal temperature changes. The assembly restores factory handling characteristics without requiring a break-in period.

Highlights

  • Complete strut assembly simplifies installation
  • Pre-assembled with mount, spring and insulators
  • Fits 2014 Ford F-150 4WD models
  • 50 years aftermarket manufacturing experience
  • Unity part number 11265 ensures correct fit

Specifications

BrandUNITY

Questions about this item

How is the Unity 11265 strut assembly installed on a 2014 Ford F-150 4WD, and what step is commonly missed?

The preassembled unit bolts directly to the vehicle using existing mounting points, eliminating the need for a spring compressor. The step often missed is torquing the top mount bolts to specification after the vehicle weight is on the suspension.

What maintenance or replacement will the Unity 11265 strut assembly need later?

As a sealed, non-serviceable assembly, it requires no internal maintenance. The complete unit is replaced when damping performance degrades or if the coil spring fatigues after extended use.

What limit appears first on the Unity 11265 strut under sustained heavy use?

The coil spring and damper valving are calibrated for the 2014 F-150 4WD weight. Under sustained heavy loads, spring sag or reduced damping control will appear before any structural failure of the mount or bearing plate.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.