We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Two red and black SAE harnesses with ring terminals and fuse holders, 2ft 18AWG cable

Unique-Bargains

Unique-Bargains SAE to Ring Terminal Harness 2ft 18AWG 10A Fuse 2pcs

SKU CH-DCP5-JYNEN

Two-foot 18 AWG SAE-to-ring-terminal harness with 10 A fuse extends 12–24 V battery charging leads on motorcycles, ATVs and trailers

  • TypeFuse Holders
  • 2ft 18AWG cable reaches distant battery terminals
  • 10A built-in fuse guards against overloads and shorts
  • Weatherproof SAE cap protects connection from moisture
  • Ring terminals fit 6.5mm studs for secure mounting
  • Two-piece pack equips both positive and negative leads

Quick-Connect SAE Harness

This two-piece SAE to ring-terminal harness provides a weather-protected quick-disconnect for 12 V to 24 V battery charging. Each 60 cm cable uses 18 AWG SPT-2 wire and includes a 10 A fuse holder with a splash-proof cap. The ring terminals fit 6.5 mm studs and are colour-coded red for positive and black for negative. The assembly suits motorcycles, ATVs, boats, trailers and similar DC systems.

Thermals Noise And Power Draw

The harness carries up to 10 A continuous with a built-in fuse that opens on overload or short circuit. No active cooling is required and the assembly adds no audible noise. Voltage drop across the 60 cm length is minimal at rated current. The fuse holder and SAE connector are rated for the same 10 A limit, so protection stays consistent from source to load.

Upgrade From Hardwired Leads

This kit replaces permanent ring-terminal pigtails that must be bolted and unbolted for every charge cycle. The SAE quick-disconnect lets you attach or remove a maintainer in seconds without tools. The jump is worth it when the battery lives in a tight compartment or when the vehicle sits for weeks between uses. It does not suit installations that need a higher current rating or a different terminal stud size.

Highlights

  • 2ft 18AWG cable reaches distant battery terminals
  • 10A built-in fuse guards against overloads and shorts
  • Weatherproof SAE cap protects connection from moisture
  • Ring terminals fit 6.5mm studs for secure mounting
  • Two-piece pack equips both positive and negative leads

Specifications

BrandUnique Bargains
TypeFuse Holders

Questions about this item

How do I install the SAE to ring terminal harness and which step is commonly missed?

Disconnect both battery cables first, then place the red ring on the positive terminal bolt and the black ring on the negative bolt before reconnecting the battery cables; people often forget to disconnect the battery before fitting the rings.

What maintenance or replacement will this harness need over time?

The built‑in 10A fuse is the only serviceable part; if it blows from an overload or short circuit, open the weatherproof cover and replace the fuse with another 10A unit.

What limit appears first during sustained use of this harness?

The 10A fuse will open before the 18AWG SPT‑2 cable or the SAE connector reaches its thermal limit, cutting power at 10 amps continuous.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.