Unique-Bargains
Unique-Bargains Motor Carbon Brushes 6.5 x 7.5 x 12.5mm 10 pcs
Ten carbon brushes sized 6.5 x 7.5 x 12.5 mm restore worn power-tool motors
- Replaces worn brushes to restore motor performance
- Exact 6.5 x 7.5 x 12.5 mm fit for many power tools
- Ten brushes per pack covers multiple repairs
- Lightweight 15 g carbon blocks reduce commutator wear
- 3 cm total length suits compact motor housings
10-piece carbon brush set for power tools
This set contains ten carbon brushes sized 6.5 x 7.5 x 12.5 mm and weighing 15 g total. They are made to fit electric hammers, drills and angle grinders. Each brush measures approximately 1.2 inches in overall length. The pack provides five pairs for multiple replacements.
Replaces worn brushes that cause motor faults
Worn brushes are a common reason for a poorly running or intermittent motor. Swapping them out can restore normal operation. The upgrade is worth it when the tool loses power, sparks excessively or starts unreliably. No other motor parts are addressed by this kit.
Simple drop-in replacement for most motor housings
Installation typically means removing the old brushes and sliding the new ones into the same holders. The main risk is selecting the wrong dimensions for a specific model. Always verify the 6.5 x 7.5 x 12.5 mm size against the tool’s manual before fitting. Incorrect fitment will not cure the fault.
Highlights
- Replaces worn brushes to restore motor performance
- Exact 6.5 x 7.5 x 12.5 mm fit for many power tools
- Ten brushes per pack covers multiple repairs
- Lightweight 15 g carbon blocks reduce commutator wear
- 3 cm total length suits compact motor housings
Specifications
| Brand | Unique Bargains |
|---|
Questions about this item
What are the exact dimensions of these carbon brushes so I can check they fit my power tool?
Each brush measures 6.5 mm thick by 7.5 mm wide by 12.5 mm long, with a total length of about 1.2 inches.
How do I install the brushes correctly and what common mistake should I avoid?
Remove the old brushes, note the orientation of the worn face, then insert the new brushes with the curved contact face matching the commutator; forcing them in backwards causes poor contact and sparking.
When should I expect to replace these brushes again?
Replace them when the carbon wears down to roughly half the original 12.5 mm length or if the motor runs intermittently, loses power or sparks excessively.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
