We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black and red DVI-I male to VGA male adapter cable, 1.45m long, 175g

Unique-Bargains

Unique-Bargains Male DVI-I to Male VGA Adapter Cable 1.45m Conduit

SKU CH-3B2Z-3J6XG

Connects a VGA monitor to a DVI-I port using a 15-pin analog interface over a 1.45 m black and red cable weighing 175 g

  • TypeHI - Conduit & Fittings
  • Connect analog monitors via 15-pin VGA to DVI-I ports
  • 45 metre cable length suits typical desk setups
  • Black and red colour coding aids quick cable identification
  • Weighs 175 grams for lightweight routing inside conduit
  • Single adapter cable connects VGA display to DVI-I source

Signal Bridge for Legacy Displays

This conduit cable links a monitor with a 15-pin VGA input to a source providing a DVI-I output. It serves builders maintaining older display hardware or integrating analogue screens into mixed-signal environments. The 1.45m span suits typical desk or rack layouts without excess slack. It addresses the specific need to translate an analogue VGA signal from a DVI-I port.

Moulded Construction and Pin Layout

The assembly weighs 175g and uses a black-and-red jacket over a single-piece conduit. Male connectors on both ends remove the need for a separate gender changer or loose adapter block. The DVI-I plug carries the analogue pins required for VGA conversion, while the VGA end secures with standard thumbscrews. This one-piece build reduces strain on panel ports during routine cable management.

Verify Port Compatibility Before Purchase

Confirm the source device presents a DVI-I socket with the four analogue pins surrounding the flat blade; a DVI-D-only port will not carry the required signal. The display must accept a standard 15-pin VGA cable. No active electronics are included, so the cable cannot bridge digital-only outputs or convert between differing refresh-rate limits. Buyers needing digital-only DVI-D or HDMI sources should seek an active converter instead.

Highlights

  • Connect analog monitors via 15-pin VGA to DVI-I ports
  • 45 metre cable length suits typical desk setups
  • Black and red colour coding aids quick cable identification
  • Weighs 175 grams for lightweight routing inside conduit
  • Single adapter cable connects VGA display to DVI-I source

Specifications

BrandUnique Bargains
TypeHI - Conduit & Fittings

Questions about this item

Does the 15-pin VGA end carry analog signals through the DVI-I interface?

Yes, the adapter routes analog video from the 15-pin VGA connector to the DVI-I port, which supports analog transmission.

What clearance does the 1.45 m cable need behind the monitor or PC?

Allow roughly 1.45 m of straight run plus a small bend radius at each connector for the 175 g cable.

Is any driver or software step required after plugging in the VGA and DVI-I ends?

No driver is needed; the connection is passive, so the display should appear once both ends are seated firmly.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.