Advance Tabco
Advance Tabco FC-1-1818-X Wall Mounted Sink 18 in x 18 in, 304
- Silver
$790.99
0.00933619BTC
In stock
Unique-Bargains
Unique-Bargains JF-S0837DL Door Lock 12V 1A 10mm 15N Push Pull
A 12 V DC push-pull solenoid with a 10 mm stroke and 15 N holding force for vending machines and office equipment
- TypeElectromagnetic Locks & Accessories
- Push-pull linear motion for automated equipment
- 10 mm stroke gives precise plunger travel
- 15 N holding force secures connected loads
- 12 V DC operation suits standard power supplies
- 16 cm wire length eases installation wiring
DC 12V Push-Pull Solenoid
This DC 12V push-pull solenoid delivers a 10mm stroke and 15N force for linear motion tasks. It suits vending machines, transport equipment, office facilities and household appliances. Buyers needing higher holding force or a different voltage should look elsewhere.
10mm Stroke and 15N Force
The plunger travels 10mm when energised, providing push or pull action on the connected load. At 15N the force handles light latches and small mechanisms but will not move heavier doors or industrial bolts. The 16cm lead wires allow straightforward wiring inside enclosures.
12V DC Operating Voltage
The coil is rated for 12V DC only; applying a higher voltage will overheat the winding and applying a lower voltage may prevent reliable actuation. Verify that your control circuit supplies exactly 12V DC before purchase.
Highlights
- Push-pull linear motion for automated equipment
- 10 mm stroke gives precise plunger travel
- 15 N holding force secures connected loads
- 12 V DC operation suits standard power supplies
- 16 cm wire length eases installation wiring
Specifications
| Brand | Unique Bargains |
|---|---|
| Type | Electromagnetic Locks & Accessories |
Questions about this item
Will the 10 mm stroke and 15 N force work with my existing 12 V access-control board?
Yes, the solenoid is rated for DC 12 V at 1 A, so a standard 12 V access-control board that can supply at least 1 A will drive the 10 mm stroke and 15 N pull-push force correctly.
How can I verify the lock is operating correctly after wiring it up?
Apply 12 V DC; the plunger should extend 10 mm with a firm push-pull action and retract cleanly when power is removed, confirming the 15 N force and return spring are functioning.
What comes in the package and do I need to buy a power supply or mounting brackets separately?
The box contains one JF-S0837DL solenoid with 16 cm leads; a 12 V 1 A DC power supply and any mounting hardware are not included and must be sourced separately.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
