We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Red and gray LED third brake light, rectangular ABS housing, 34x5x2.2cm

Unique-Bargains

Unique-Bargains High Level Third Rear Brake Stop Light 8E9945097B for Audi A4 Quattro Avant Wagon 2005-2008

SKU CH-FPF7-CS37T

High-mount LED third brake light with full LED chip and ABS housing fits Audi A4 and S4 Avant wagons 2005-2008, replaces OEM 8E9945097B

  • QualityAftermarket OEM
  • Bright LED chip improves rear visibility
  • Plug-and-play fitting replaces OEM 8E9945097B directly
  • ABS housing resists rust and corrosion for long service life
  • Red LED light source operates on 12 V DC vehicle supply
  • Fits Audi A4 and S4 Avant Quattro models 2005 to 2008

Third brake light for Audi Avant

This aftermarket LED stop lamp fits Audi A4 and S4 Avant Quattro wagons produced between 2005 and 2008. It replaces OEM part 8E9945097B and mounts at the top of the rear hatch. The unit suits saloon owners who need a direct-fit replacement for a cracked or faded original.

12 V LED operation and ABS housing

The lamp runs on the vehicle's 12 V DC system and uses a full LED chip array that illuminates instantly when the brake pedal is pressed. Its red and grey ABS housing resists rust and corrosion, so the lens stays clear through wet weather and road salt exposure.

Plug-and-play fit with instant response

Installation requires no wiring changes; the two-pin connector plugs into the factory harness and the light activates immediately under sustained braking. The 34 cm long unit draws minimal current, leaving the electrical system unaffected during long stops in traffic.

Highlights

  • Bright LED chip improves rear visibility
  • Plug-and-play fitting replaces OEM 8E9945097B directly
  • ABS housing resists rust and corrosion for long service life
  • Red LED light source operates on 12 V DC vehicle supply
  • Fits Audi A4 and S4 Avant Quattro models 2005 to 2008

Specifications

BrandUnique Bargains
QualityAftermarket OEM

Questions about this item

How is the 8E9945097B third brake light installed on my Audi A4 Avant?

Remove the factory unit, connect the 2-pin plug to the 12V DC harness, and snap the ABS housing into the roof recess. The step most people miss is testing the light with the brake pedal pressed before driving off.

What maintenance will this LED third brake light need over time?

The sealed full-chip LED array and ABS lens are non-serviceable; no bulbs to replace. Only occasional cleaning of the red-grey housing and checking the 2-pin connector for corrosion are required.

What is the first limitation that appears during extended braking?

Continuous brake-pedal activation keeps the 12V DC LEDs lit, so heat builds in the 34 cm ABS housing. The thermal limit of the sealed LED module is reached before any voltage drop occurs.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.