Unique-Bargains
Unique-Bargains Gold Tone Aluminum Heatsink Set 14x14x7mm 9x9x5mm 10pcs
Set of ten self-adhesive aluminium heatsinks in two sizes for Raspberry Pi, ICs and small electronics
- Efficient heat dissipation for small components backed by aluminium alloy construction
- Pre-applied adhesive tape simplifies installation on Raspberry Pi and other boards
- Two form factors included covering 14×14×7 mm and 9×9×5 mm footprints
- Gold-tone finish adds visual distinction while maintaining thermal performance
- Ten-piece kit supplies five of each size for multiple cooling zones
Gold-Tone Aluminium Heatsink Kit
The Unique-Bargains set contains ten self-adhesive aluminium heatsinks in two sizes. Five pieces measure 14 x 14 x 7 mm and five measure 9 x 9 x 5 mm, all finished in a gold tone. They are designed for Raspberry Pi boards and other small electronic components that lack factory cooling.
Makers cooling Raspberry Pi or driver chips
Hobbyists adding passive cooling to stepper motor drivers, ICs or 3D-printer electronics will find the two heights useful. Builders who need thermal pads with electrical conductivity or larger heatsinks for desktop memory modules should look elsewhere.
Peel-and-stick mounting on clean surfaces
Each heatsink uses a non-conductive adhesive backing; press firmly onto a degreased chip for a secure bond. The adhesive is not reusable, so misalignment means replacing the piece. No tools or thermal paste are required.
Highlights
- Efficient heat dissipation for small components backed by aluminium alloy construction
- Pre-applied adhesive tape simplifies installation on Raspberry Pi and other boards
- Two form factors included covering 14×14×7 mm and 9×9×5 mm footprints
- Gold-tone finish adds visual distinction while maintaining thermal performance
- Ten-piece kit supplies five of each size for multiple cooling zones
Specifications
| Brand | Unique Bargains |
|---|
Questions about this item
Does the 14 x 14 x 7 mm heatsink need any extra thermal paste or pads to stick to a Raspberry Pi chip?
No. Each piece ships with ordinary self-adhesive backing that is not thermally conductive; peel the liner and press it onto the clean chip surface.
Will the 9 x 9 x 5 mm heatsinks fit the stepper motor driver modules I already use on my 3D printer?
The small heatsinks measure 9 x 9 x 5 mm and are intended for cooling chips and stepper motor driver modules, so they should cover the driver ICs on common printer boards.
How can I confirm the heatsinks are dissipating heat after I install them?
Touch the gold-tone aluminium fins after the device has run under load; they should feel noticeably warmer than ambient, showing heat is moving from the chip into the heatsink.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Black Box Corporation
Black Box Corporation CAT6 EZ-RJ45 Modular Plugs 100-Pack
$95.99
0.00115626BTC
In stock
