Unique-Bargains
Unique-Bargains CR1220 Battery Holder 5pcs Black
Pack of five black plastic holders for CR1220 button cells with gold-tone contacts
- Holds CR1220 cells securely with SMD-type footprint
- Compact 15 x 15 x .16 mm body fits tight PCB layouts
- Gold-tone contacts on black plastic resist corrosion
- Five holders per pack support multiple builds or spares
- Lightweight 4 g total adds minimal mass to assemblies
CR1220 Battery Holder Pack
This pack contains five black plastic holders designed for CR1220 lithium button cells. Each holder uses an SMD-type footprint measuring 15 x 15 x 4 mm with gold-tone contacts. The lightweight units weigh roughly 4 g in total and ship without batteries included.
Suits DIY repairs and small electronics
Hobbyists replacing coin cells on motherboards, remotes or medical devices will find the surface-mount format convenient. Builders needing through-hole pins, larger capacities or holders for other cell sizes should look elsewhere.
Simple surface-mount installation
The holder pads are soldered directly to the PCB using standard reflow or hand-soldering techniques. Misalignment during placement is the most common issue, so check pad orientation before heating.
Highlights
- Holds CR1220 cells securely with SMD-type footprint
- Compact 15 x 15 x .16 mm body fits tight PCB layouts
- Gold-tone contacts on black plastic resist corrosion
- Five holders per pack support multiple builds or spares
- Lightweight 4 g total adds minimal mass to assemblies
Specifications
| Brand | Unique Bargains |
|---|
Questions about this item
Does the CR1220 holder need a specific PCB footprint to solder in place?
The holder uses an SMD type design with a 15 x 15 mm body size and 0.16 mm height, so the PCB pads must match that footprint.
Can I mix these holders with older through-hole battery sockets on the same board?
Yes, the SMD holders sit flat on the surface while through-hole parts use drilled holes, so they can share a board without mechanical conflict.
How do I verify the holder grips the cell correctly after soldering?
Insert a CR1220 cell; the gold-tone metal contacts should hold it firmly with no wobble, and the voltage should read at the solder pads.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
