We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black plastic rectangular battery holder with two stacked rows for four AA cells and a 15 cm wire lead

Unique-Bargains

Unique-Bargains Black Plastic Wired Double Layers 4 x 1.5V AA Battery Case Holder

SKU CH-5FAR-78C4C

Holds four 1.5 V AA cells in a double-layer black plastic case with 15 cm wire leads

  • TypeBattery Protectors
  • Holds four AA cells for portable power
  • Double-layer spring clips secure batteries firmly
  • 15 cm leads give flexible wiring options
  • Compact 58 × 32 × 29 mm body fits tight spaces
  • Lightweight 10 g design adds minimal bulk

Battery Case Holder

This black plastic holder accommodates four 1.5 V AA batteries in a double-layer layout with spring clips for secure contact. A 15 cm wired connector is attached for easy integration into RC toys, drones or other low-power projects. Batteries are not included.

Upgrade From Loose Cells

The case replaces ad-hoc battery taping or single-cell holders by keeping four cells aligned and connected through one cable. The jump is worth it when a project needs a compact 6 V nominal supply without soldering individual contacts.

Capacity And Headroom

The holder is rated for a maximum of 10 W and 2 A continuous current, suitable for small motors, receivers or lighting. It runs out of headroom for higher-draw servos or multi-motor setups that exceed those limits.

Highlights

  • Holds four AA cells for portable power
  • Double-layer spring clips secure batteries firmly
  • 15 cm leads give flexible wiring options
  • Compact 58 × 32 × 29 mm body fits tight spaces
  • Lightweight 10 g design adds minimal bulk

Specifications

BrandUnique Bargains
TypeBattery Protectors

Questions about this item

What are the dimensions of this 4 x AA battery holder?

The case body measures 58 x 32 x 29 mm, or 2.3 x 1.3 x 1.1 inches, and each wire lead is 15 cm (5.9 in) long.

How do I connect the wired leads without reversing polarity?

Solder or crimp the two leads to your device, matching the spring contact side to positive and the flat contact side to negative; the double-layer layout keeps cells in series.

When should I replace the plastic holder itself?

Replace it if the plastic cracks, the springs lose tension, or the wire insulation shows heat damage from sustained loads near the 10 W or 2 A limits.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.