Unique-Bargains
Unique-Bargains 9V Battery Clip T-Type 15cm
A 15 cm T-type connector with stripped, tinned red and black leads for wiring a 9 V battery into DIY circuits
- T-type cap snaps securely onto 9V blocks
- 15 cm pre-stripped leads ready for soldering
- Red and black wires simplify polarity identification
- Lightweight plastic housing adds minimal bulk to projects
- Battery not included — connector only
9V Battery Clip for DIY Projects
The Unique-Bargains T-type connector provides a secure plastic holder for standard 9V block batteries. It is intended for hobbyists and students building low-voltage circuits or prototype boards. The stripped and tinned leads simplify soldering directly to a PCB or breadboard wires. Battery is not included with the connector.
Thermals Noise and Power Draw
As a passive wiring accessory the clip generates no heat and produces no audible noise during operation. It adds negligible resistance to the circuit so power draw is determined entirely by the connected load and battery capacity. The plastic shell remains at ambient temperature under normal use.
15cm Tinned Leaid Pair
Two colour-coded conductors measuring 15 centimetres terminate in pre-tinned ends for immediate soldering. Red and black insulation allows quick polarity identification without a multimeter. The hard plastic T-type cap holds the battery firmly while the flexible wires route easily inside small enclosures.
Highlights
- T-type cap snaps securely onto 9V blocks
- 15 cm pre-stripped leads ready for soldering
- Red and black wires simplify polarity identification
- Lightweight plastic housing adds minimal bulk to projects
- Battery not included — connector only
Specifications
| Brand | Unique Bargains |
|---|
Questions about this item
How do I connect the 15cm stripped and tinned leads to my circuit?
Solder the red lead to the positive terminal and the black lead to the negative terminal of your circuit board or device. Ensure the T-type plastic cap snaps firmly onto the 9V battery terminals for a secure mechanical connection.
Will the plastic T-type connector or wires degrade and need replacement over time?
The hard plastic shell and tinned copper leads are durable for typical DIY use. Replace the clip if the plastic cracks, the spring contacts lose tension, or the wire insulation becomes brittle and exposes the conductor.
What is the current limit before the 15cm leads or connector overheat during sustained use?
The 15cm stripped and tinned leads and T-type connector are designed for standard 9V battery loads. Sustained high-current draw beyond typical low-power electronics may cause the wires or spring contacts to heat up and increase voltage drop.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
