Unique-Bargains
Unique-Bargains 9V Battery Clip Connector I-Type 15cm 2-Pack
Two I-type 9 V battery clips with 15 cm colour-coded leads for soldering into DIY projects
- I-type hard-shell clip secures 9 V battery
- 15 cm pre-stripped tinned leads ready to solder
- Red and black wires simplify polarity identification
- Two connectors per pack support multiple DIY projects
- Plastic housing protects terminals during handling
9 V Battery Clip Connector I-Type 15 cm
This two-pack supplies I-type snap connectors with 15 cm stripped and tinned leads for 9 V batteries. The hard plastic shell holds the contacts firmly while the colour-coded red and black wires simplify polarity identification. They are intended for hobbyists, students and technicians building or repairing battery-powered circuits. No batteries are included with the connectors.
Practical limits of the snap interface
The I-type snap fits standard 9 V battery terminals but cannot mate with other voltages or connector styles. The 15 cm lead length restrains placement distance between the battery and the circuit board. The plastic shell is not rated for high-temperature or outdoor exposure, so sustained heat or moisture may degrade the housing. Current capacity is limited by the thin tinned wires and the snap contact area.
Replaces loose wires or damaged clips
These connectors replace frayed flying leads, broken battery snaps or makeshift solder joints on existing 9 V projects. The pre-stripped ends save time compared to cutting and tinning raw wire. The upgrade is worthwhile when the original clip has lost spring tension or when a permanent, polarised connection is needed for repeated battery changes. They do not suit applications requiring waterproofing, locking retention or higher current than the snap interface allows.
Highlights
- I-type hard-shell clip secures 9 V battery
- 15 cm pre-stripped tinned leads ready to solder
- Red and black wires simplify polarity identification
- Two connectors per pack support multiple DIY projects
- Plastic housing protects terminals during handling
Specifications
| Brand | Unique Bargains |
|---|
Questions about this item
Should I choose the 2-pack or buy single clips for my project?
The product is sold as a 2-pack containing two I-type connectors, each with 15cm red and black leads ready for soldering.
What does the 15cm wire length mean when I solder this into a device?
Each clip provides 15cm of stripped and tinned wire, giving enough slack to reach a PCB or terminal block inside a typical enclosure.
How does the I-type hard-shell connector fit a standard 9V battery?
The hard plastic I-type buckle snaps onto the battery terminals, with one red lead for positive and one black lead for negative polarity.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
