We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Ten black I-type 9V battery clips with 15cm red and black tinned leads

Unique-Bargains

Unique-Bargains 9V Battery Clip Connector 10Pcs 15cm

SKU CH-T1W2-JDA08

Pack of ten 9 V battery clips with 15 cm tinned leads for low-current DIY wiring

  • TypeConnectors
  • 10-pack supplies multiple projects
  • 15 cm leads reach typical board layouts
  • 19 g total weight keeps builds light
  • Red and black wires simplify polarity identification
  • I-type plastic shell fits standard 9 V batteries

9 V battery clip set

This pack contains ten I-type plastic connectors with 15 cm stripped and tinned leads. Each clip fits a standard 9 V battery and provides one red and one black wire for quick polarity identification in DIY electronics or hobby projects.

Solder-ready leads with current limits

The 15 cm wires are pre-stripped and tinned, so they can be soldered directly to a PCB or terminal block without extra preparation. The supplier notes that the wires are thin and the structure suits only very small current loads; stop use if the wires become hot and do not connect the clips to circuits that draw large current.

Low-current 9 V interface constraints

The connector is designed for low-power applications such as sensor modules, small toys or prototype circuits. It cannot supply the current needed for motors, high-brightness LEDs or other loads that would heat the thin leads, so the practical limit is the wire gauge rather than the battery chemistry.

Highlights

  • 10-pack supplies multiple projects
  • 15 cm leads reach typical board layouts
  • 19 g total weight keeps builds light
  • Red and black wires simplify polarity identification
  • I-type plastic shell fits standard 9 V batteries

Specifications

BrandUnique Bargains
TypeConnectors

Questions about this item

How can I confirm the 15 cm leads are making solid contact with a 9 V battery after soldering?

Snap the I-type clip onto the battery, power your low-current circuit, and verify the red and black wires stay cool and the voltage reads correctly at the load.

What comes in the pack and what must I supply myself?

The pack contains 10 black-and-red I-type clips with 15 cm pre-tinned leads; you must provide the 9 V batteries and any solder or heat-shrink for your project.

Which version should I choose for a low-current DIY build?

This single 15 cm, 2-wire I-type variant is the only one listed and is intended for very small current loads only.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.