Unique-Bargains
Unique-Bargains 900M-T-IS Soldering Iron Tip 3pcs Pointy Curved 43mm 6.5mm
Three pointy curved tips measuring 43 mm long with a 6.5 mm shank fit 900M series irons for detailed soldering work
- Long-lasting tip resists oxidation for extended use
- Pointy curved design reaches tight joints with precision
- 43 mm length fits 900M series soldering irons
- 5 mm shank diameter ensures secure heater fit
- Three tips per pack provides ready replacements
Product Identity
This pack contains three 900M-T-IS soldering iron tips with a pointy curved profile. They suit hobbyists and technicians who need a fine point for detailed circuit-board work or component rework.
Thermals and Life
The supplier advises operating at 800 F or 427 C maximum to reduce detinning and extend tip life. Wipe only with sulfur-free cellulose sponges and feed rosin-core solder to the working end regularly for consistent heat transfer.
Fitment Decider
Each tip measures 43 mm total length with a 6.5 mm shank diameter, equivalent to 1.7 inches by 0.25 inches. Verify that your iron accepts this shank size before purchasing; tips with a different shank will not seat correctly.
Highlights
- Long-lasting tip resists oxidation for extended use
- Pointy curved design reaches tight joints with precision
- 43 mm length fits 900M series soldering irons
- 5 mm shank diameter ensures secure heater fit
- Three tips per pack provides ready replacements
Specifications
| Brand | Unique Bargains |
|---|
Questions about this item
How do I install the 900M-T-IS tip on my soldering iron, and what step causes a loose fit?
Unscrew the old tip, insert the 6.5 mm shank fully into the barrel, then tighten the retaining nut; skipping the full insertion leaves the tip wobbling and reduces heat transfer.
What maintenance will the 900M-T-IS tips need over time to prevent oxidation and detinning?
Operate at 800 °F / 427 °C or lower, wipe only on a wet sulfur-free cellulose sponge, and feed rosin-core solder to the working end regularly to keep the plating intact.
What is the first limit that appears when using the 900M-T-IS tip continuously at high power?
Exceeding 800 °F / 427 °C causes rapid detinning of the tip surface, so temperature control is the primary constraint during sustained soldering sessions.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
