We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Six black plastic AA battery holders with red and black wires attached

Unique-Bargains

Unique-Bargains 6 Pcs Wired AA Battery Holder Black

SKU CH-P7TK-ZDBQW

Holds six single AA cells with pre-wired 8 cm leads and snap-in plastic cases for quick power connections

  • TypeBattery Protectors
  • Holds one AA cell for compact power
  • Wired 3.1" leads simplify connections
  • Weld-leg design eases battery insertion
  • Small 2.3" x 0.67" x 0.55" case fits tight spaces
  • Six-piece pack supplies multiple projects

Battery Holder for Single AA Cell

This pack provides six wired holders each designed to secure one 1.5 V AA battery. The plastic case measures 5.8 by 1.7 by 1.4 cm with an 8 cm lead, making it suited for hobbyists building low-power RC or drone projects.

Welded Leads for Direct Connection

Each unit features a weld-leg design that lets you insert the cell and solder the 3.1-inch wires straight to a board or connector. No active cooling or power regulation is involved, so thermals and noise are not a factor in normal use.

Six Units in One Pack

The bundle simply multiplies the single holder six times, giving enough spares for multiple prototypes or replacements. No software, mounting hardware or additional adapters are supplied beyond the wired cases themselves.

Highlights

  • Holds one AA cell for compact power
  • Wired 3.1" leads simplify connections
  • Weld-leg design eases battery insertion
  • Small 2.3" x 0.67" x 0.55" case fits tight spaces
  • Six-piece pack supplies multiple projects

Specifications

BrandUnique Bargains
TypeBattery Protectors

Questions about this item

How do I install the AA battery and what is the common mistake with the wired connector?

Insert one AA battery into the plastic case observing the polarity markings, then solder or crimp the two pre-attached 8 cm wires to your circuit; the step often missed is securing the wire joints so vibration does not pull them loose.

What maintenance or replacement will this battery holder need over time?

The plastic case and wire insulation can become brittle with age; replace the holder if the wires fray, the solder tabs lift, or the battery no longer makes firm contact.

What limit appears first when the holder is used continuously in a high-drain device?

The thin 8 cm wires and spring contacts heat up quickly, so voltage sag at the 1.5 V output becomes the first bottleneck under sustained load.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.