We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in

Unique-Bargains

Unique-Bargains 5.5M 1.27mm 26 Pin IDC Ribbon Cable Conduit

SKU CH-WDAW-1FMKS

Flat IDC ribbon cable with 26 pins at 1.27 mm pitch, 5.5 m long for JTAG debugging and ISP programming

  • TypeHI - Conduit & Fittings
  • 5 metre length gives ample reach for internal wiring
  • 27 mm pitch matches standard IDC connectors for direct fit
  • 26 conductors carry multiple signals in a single flat cable
  • 5 cm wide ribbon keeps routing tidy inside tight enclosures

5.5 m IDC ribbon cable for JTAG debuggers

This 5.5 metre flat ribbon cable has a 1.27 mm pitch and 26 pins. It is designed for Atmel AVR JTAG debuggers, in-system programmers and ISP download tasks. The cable width is 3.5 cm and the total length is 18 ft.

Thermals, noise and power draw

As a passive plastic conduit, the cable produces no heat, no audible noise and draws no power during normal use. It simply carries signals between the programmer and the target board without active components.

Highlights

  • 5 metre length gives ample reach for internal wiring
  • 27 mm pitch matches standard IDC connectors for direct fit
  • 26 conductors carry multiple signals in a single flat cable
  • 5 cm wide ribbon keeps routing tidy inside tight enclosures

Specifications

BrandUnique Bargains
TypeHI - Conduit & Fittings

Questions about this item

How do I connect the 26-pin IDC connectors to my JTAG debugger without bending the 1.27mm pitch pins?

Align the keyed IDC socket with the header, press straight down using even finger pressure across the 3.5 cm wide cable body until the latch clicks, avoiding any rocking motion that can bend the fine-pitch contacts.

Will the 5.5 m flat ribbon cable need replacement if the plastic insulation cracks from repeated flexing?

Yes, the plastic-insulated 1.27 mm pitch conductors can fatigue at sharp bends over time; replace the cable if the insulation shows cracks or the 26-pin connectors become intermittent.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.