Unique-Bargains
Unique-Bargains 4pcs Black 9V Battery Storage Case Slot Holder w 5.9" Wires
Holds four 9V batteries in compact black plastic cases with 5.9" wire connectors, weighing 34g total
- Holds four 9V batteries securely in compact 5.4 × 3 × 2.1 cm cases
- Ready-to-use 5.9" wire leads simplify circuit connections
- Lightweight 34 g plastic-and-metal construction adds minimal bulk
- Black finish resists visible wear in workshop environments
- Rated for up to 15 W and 2 A continuous operation
Battery holder for 9V cells
This set includes four black plastic cases that each accept a single 9V battery and come pre-wired with a 5.9" lead. They are intended for hobbyists or technicians who need a quick way to connect 9V cells to a project without soldering directly to the battery terminals. Battery is not included.
Current limit and heat note
The supplier specifies a maximum working current of less than 2A and a maximum power of less than 15W during use. Users should monitor the battery for heat generation and avoid using poor quality cells that could exceed these limits.
Sustained load behaviour
Under continuous operation the holder must stay within the 2A and 15W thresholds to avoid overheating the battery or the plastic body. The 34g weight and compact 5.4 x 3 x 2.1cm size make it suited for portable or enclosed builds where long runs stay within the stated ratings.
Highlights
- Holds four 9V batteries securely in compact 5.4 × 3 × 2.1 cm cases
- Ready-to-use 5.9" wire leads simplify circuit connections
- Lightweight 34 g plastic-and-metal construction adds minimal bulk
- Black finish resists visible wear in workshop environments
- Rated for up to 15 W and 2 A continuous operation
Specifications
| Brand | Unique Bargains |
|---|
Questions about this item
How do I install a 9V battery into the 5.4 x 3 x 2.1cm holder and connect the 5.9" wires?
Slide the battery into the plastic slot until the metal contacts snap onto the terminals, then route the 15cm wires to your device; the step people miss is checking polarity markings on the holder before closing the cover.
What maintenance or replacement will the 34g plastic and metal case need over time?
Inspect the spring contacts for corrosion and the 5.9" wire insulation for cracking every few months; replace the holder if the contacts lose tension or the plastic body shows heat deformation.
What limit appears first when the holder runs continuously at the 15W, 2A rating?
The 15W power ceiling is reached before the 2A current limit, so sustained loads near 15W will cause the battery and contacts to heat up first, triggering the thermal warning in the instructions.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
