We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Two black plastic AAA battery holders, 53 by 21mm

Unique-Bargains

Unique-Bargains 3x AAA Battery Holder 2-Pack Black 53 x 21mm

SKU CH-2WN8-6H50H

Holds three 1.5 V AAA batteries per case, supplied as a two-pack of black plastic and metal holders measuring 53 x 21 mm

  • Holds three 1.5V AAA batteries for compact power
  • Two holders per pack for spare or dual-device use
  • 53 x 21 mm size fits tight compartments
  • 11 g weight adds minimal bulk to projects
  • Plastic and metal construction withstands regular handling

3x AAA Battery Holder 2-Pack

This pack contains two black plastic and metal holders sized 53 x 21 mm that each accept three 1.5 V AAA batteries. Weighing 11 g apiece they are intended for flashlights torches and similar low-power devices.

Low-current portable projects

Suitable for hobbyists and repairers who need a compact holder for temporary or permanent wiring where the load stays below 10 W and 2 A. Not for builds that require higher current capacity waterproof sealing or a built-in switch.

10 W 2 A operating limit

The supplier specifies that the maximum power must stay under 10 W and the working current under 2 A when the holder is in use. This single electrical ceiling decides whether the part fits your circuit.

Highlights

  • Holds three 1.5V AAA batteries for compact power
  • Two holders per pack for spare or dual-device use
  • 53 x 21 mm size fits tight compartments
  • 11 g weight adds minimal bulk to projects
  • Plastic and metal construction withstands regular handling

Specifications

BrandUnique Bargains

Questions about this item

How often will the plastic housing or metal contacts need replacing under normal use?

The holder uses a plastic body and metal contacts sized at 53 x 21mm; no maintenance schedule is defined, so inspect contacts for corrosion or melting if you exceed the 2A current limit.

What stops me from drawing more power during a long run?

The supplier states maximum power must stay below 10W and working current below 2A; exceeding either will cause overheating and becomes the first hard limit.

How hot or noisy does the case get when left on all day?

The case itself is silent, but the spec warns to watch battery heat generation and avoid poor-quality cells; sustained loads near 10W will warm the holder noticeably.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.