We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Ten brass MK8 nozzles 0.2 to 1mm diameters in a set

Unique-Bargains

Unique-Bargains 3D Printer Nozzle Set MK8 1.75mm Brass 0.2-1mm 10pcs

SKU CH-8DP7-FGDT9

Set of ten brass MK8 nozzles for 1.75 mm filament, covering 0.2 mm to 1 mm diameters

  • Works with 1.75 mm filament MK8 printers
  • Brass construction resists rust and erosion
  • Stamped sizes let you pick the right nozzle fast
  • Ten nozzles cover 0.2 to 1 mm diameters
  • Clean M6 threads install straight into the hot end

Compatible MK8 Nozzle Set for 1.75mm Filament

This set supplies ten brass nozzles made for MK8-style hot ends that accept 1.75mm filament. It covers five diameters from 0.2mm to 1mm so users can switch between fine detail and fast draft prints. The pack is aimed at hobbyists and small-shop operators who run non-abrasive materials such as PLA, ABS or PCL and want a ready assortment of sizes.

Brass Construction with M6 Thread and Stamped Size

Each nozzle is machined from brass for corrosion resistance and long service life. The M6 thread with a 5mm length screws cleanly into standard MK8 heater blocks, and the size is stamped on the side for quick identification. The bores are consistent and the threads are well formed, reducing the risk of leaks or jams during everyday printing.

Practical Limits of Brass Nozzles on MK8 Hot Ends

Brass works well with non-abrasive filaments but wears quickly with carbon-fibre, glow-in-the-dark or metal-filled materials, so those filaments are not a good match. The largest 1mm bore pushes more plastic but demands higher flow rates that some MK8 setups cannot sustain without tuning. Users must also recalibrate the nozzle-to-bed gap after every swap to maintain first-layer quality.

Highlights

  • Works with 1.75 mm filament MK8 printers
  • Brass construction resists rust and erosion
  • Stamped sizes let you pick the right nozzle fast
  • Ten nozzles cover 0.2 to 1 mm diameters
  • Clean M6 threads install straight into the hot end

Specifications

BrandUnique Bargains

Questions about this item

What MK8 thread standard do these nozzles use and what filament size does it limit you to?

They use an M6 thread with a 5 mm thread length and accept only 1.75 mm filament.

What are the overall dimensions and hex size needed to install them?

Each nozzle measures 13 mm long by 6 mm in diameter, requiring a 6 mm socket or spanner.

What temperature should the hotend reach before you unscrew the old nozzle?

Heat the block to 180–220 °C for PLA or 240–280 °C for ABS, then remove the old nozzle while hot.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.