Unique-Bargains
Unique-Bargains 24 Pin IDC Flat Ribbon Cable 50cm 3 Pcs
Pack of three 50 cm IDC flat ribbon cables with 24-pin female connectors on 2.54 mm pitch for JTAG and ISP programming
- TypeHI - Conduit & Fittings
- Ready for AVR JTAG debugging with 24-pin IDC connectors
- Three cables included for multiple programmer setups
- 50 cm length fits typical bench layouts
- 54 mm pitch aligns with standard header rows
24-pin IDC ribbon cable set
This pack contains three flat ribbon cables each fitted with two female IDC connectors. They are intended for connecting Atmel AVR JTAG debuggers, in-system programmers and ISP download tools.
Thermals noise and power
The cables carry only low-level signalling currents so they generate no measurable heat and operate silently. Power draw is limited to the signal lines themselves and adds no load to a system supply.
Highlights
- Ready for AVR JTAG debugging with 24-pin IDC connectors
- Three cables included for multiple programmer setups
- 50 cm length fits typical bench layouts
- 54 mm pitch aligns with standard header rows
Specifications
| Brand | Unique Bargains |
|---|---|
| Type | HI - Conduit & Fittings |
Questions about this item
How do I fit the 2.54mm pitch 24 pin IDC connectors onto the board headers without bending pins?
Align the keyed notch on each female connector with the matching slot on the header, then press straight down evenly across the full width until both rows of 24 contacts seat fully.
What upkeep will the 50cm gray, fuschia and black ribbon assembly need over time?
Inspect the insulation for cracks and the IDC contacts for oxidation; if any conductor shows damage, replace the whole 86g cable rather than attempting a repair.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



