Unique-Bargains
Unique-Bargains 2 Pcs 100x9mm 1mm Pitch 8 Pins FPC Flex Wire FFC Flexible Flat Ribbon Cable
Two 100 mm flexible flat cables with 1 mm pitch and eight pins for LCD, TV, laptop and other device connections
- 8 pins with 1 mm pitch suit many LCD and laptop boards
- 100 mm length gives reach for internal routing in tight cases
- Rated to 80 °C for reliable operation in warm enclosures
- 60 V dielectric strength supports low-voltage signal lines safely
- Two cables included so a spare is on hand for repairs
Two-piece 8-pin FFC kit
This pack contains two flexible flat cables each measuring 100 millimetres long with a 1 millimetre pitch and eight conductors. They suit internal connections in LCD panels, laptops, car navigation units, DVD players, printers and similar compact electronics. The white and blue PVC insulation protects copper traces rated for 60 volts dielectric strength. Operating temperature reaches 80 °C.
Replaces damaged or short factory ribbons
Swap a torn, corroded or kinked original cable when the connector and pin count match exactly. The upgrade is worthwhile only if the existing flex has failed or a longer reach is required within the same 8-pin 1 mm pitch footprint. Do not use if the device needs a different pin count, pitch or voltage rating.
Limited to 1 mm pitch 8-pin interfaces
The cable works solely with sockets accepting 1 mm pitch 8-position FFC or FPC connectors. It cannot connect to wider pitches, higher pin counts or board-to-board headers. The 100 millimetre length and 0.35 inch width restrict routing to tight internal spaces; longer runs or external use are not supported.
Highlights
- 8 pins with 1 mm pitch suit many LCD and laptop boards
- 100 mm length gives reach for internal routing in tight cases
- Rated to 80 °C for reliable operation in warm enclosures
- 60 V dielectric strength supports low-voltage signal lines safely
- Two cables included so a spare is on hand for repairs
Specifications
| Brand | Unique Bargains |
|---|
Questions about this item
What is the 1 mm pitch and 100 mm length of this FFC ribbon cable?
The cable has a 1 mm pin pitch, 8 pins, and a total length of 100 mm with a width of 9 mm.
How do I insert the 8-pin FFC into its ZIF connector without damaging the contacts?
Lift the connector actuator, slide the blue reinforced end straight in with contacts facing the correct direction, then lower the actuator to lock it.
When should I replace this 60 V, 80 °C rated flexible flat cable?
Replace it if the copper traces crack, the PVC insulation discolours from heat, or the connector end frays after repeated flexing.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



