We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Gray 16-wire flat ribbon cable with IDC connectors at both ends, 100cm long

Unique-Bargains

Unique-Bargains 16 Pin IDC Flat Ribbon Cable 100cm

SKU CH-EB26-9HMPY

16-wire flat ribbon cable with dual female IDC connectors, 2.54 mm pitch, rated to 300 V and 100 cm long

  • TypeHI - Conduit & Fittings
  • 16-pin IDC connectors for direct AVR JTAG programming
  • 54 mm pitch matches standard header spacing
  • 300 V withstand rating handles signal-level voltages
  • 100 cm length gives flexible routing inside enclosures

16-pin IDC ribbon cable for AVR JTAG programmers

This 100 cm flat ribbon cable carries two female IDC connectors at 2.54 mm pitch. It is built for Atmel AVR JTAG debuggers and in-system programmers that use a standard 16-wire IDC interface. The grey, fuschia and black plastic assembly weighs 34 g and is rated for 300 V.

Pitch and pin count define compatibility

The cable only fits headers with 2.54 mm spacing and exactly 16 pins in a 2 × 8 arrangement. Boards that use a different pitch, a 10-pin or 20-pin IDC header, or a keyed connector cannot use this cable. Buyers needing a different pin count or pitch should select another part.

Highlights

  • 16-pin IDC connectors for direct AVR JTAG programming
  • 54 mm pitch matches standard header spacing
  • 300 V withstand rating handles signal-level voltages
  • 100 cm length gives flexible routing inside enclosures

Specifications

BrandUnique Bargains
TypeHI - Conduit & Fittings

Questions about this item

How does the 2.54 mm pitch affect the cable when it is connected to a JTAG debugger?

The 2.54 mm pitch matches the standard header spacing on most Atmel AVR JTAG debuggers, so the 16 pin female IDC connectors seat directly without adapters.

What does the 300 V withstand voltage rating limit in practice?

The 300 V rating caps the maximum voltage the insulation can handle; the cable is intended for low voltage signal use such as ISP programming, not for mains or high voltage circuits.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.