We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Two yellow gas spring struts with silver rods and mounting brackets, fifteen inches extended

Unique-Bargains

Unique-Bargains 15" 100N Yellow Gas Spring Strut Compressor 2pcs

SKU CH-GEVY-9YHMB

A pair of 15-inch, 100 N gas springs with M8 brackets that lift and hold bonnets, hatches or RV compartments weighing 17–25 lb

  • Installs in minutes with basic hand tools
  • 100N force per strut lifts 17-25 lb loads
  • 15" extended length fits many hatches and lids
  • Corrosion-resistant yellow finish with M8x1.25 threads
  • Includes two struts, four brackets and four nuts

Universal lift supports for hoods and hatches

These yellow gas springs extend to 38.5 cm and compress to 23 cm with a 100 N force rating per strut. The pair includes four M8 mounting brackets and nuts for direct bolt-on installation using basic hand tools.

Suitable for lids weighing 17 to 25 pounds total

They work on car bonnets, boat hatches and RV compartments within that weight range. Builders needing support above 25 pounds or a different thread pitch should select another kit.

Consistent force through the full stroke

The 100 N rating is maintained from the 23 cm compressed length to the 38.5 cm extended position without the drop-off seen in short-burst testing. Rod and housing dimensions stay within the listed tolerances during repeated cycles.

Highlights

  • Installs in minutes with basic hand tools
  • 100N force per strut lifts 17-25 lb loads
  • 15" extended length fits many hatches and lids
  • Corrosion-resistant yellow finish with M8x1.25 threads
  • Includes two struts, four brackets and four nuts

Specifications

BrandUnique Bargains

Questions about this item

What mounting hardware must I already have to install the 100N gas springs?

The kit includes four M8x1.25 nuts and four brackets with 8mm round and 10x8mm oval holes; you only need a socket or spanner that fits M8 threads.

Will these 15-inch struts replace the original 9.06-inch compressed-length units on my boat hatch?

Yes, if the original compressed length is 23cm and extended length 38.5cm; the 100N force per strut supports 17 to 25 pounds total.

How can I verify the 100N force is correct after fitting the pair?

The hatch should stay open hands-free at full 38.5cm extension and require roughly 22.5lb to begin closing; it must not support more than 25lb total.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.