We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Two white metal gas struts with black rods, 10 inch extended length, sold as a pair

Unique-Bargains

Unique-Bargains 10 inch 60Lbs White Gas Strut Compressor 2pcs

SKU CH-49S1-VMHW4

Two 10-inch white gas struts rated at 60 lbs each lift and hold heavy hoods, hatches or covers on cars, boats and RVs

  • Supports heavy lids with 60 lbs force per strut
  • Quick installation using only basic hand tools
  • White metal construction resists corrosion for long life
  • Universal fit for cars, boats, RVs and buses
  • 10 inch extended stroke gives ample hood clearance

Universal Gas Struts for Vehicle Covers

These two white gas struts extend to 25.4cm and compress to 16.3cm, delivering 60Lbs of force each. They fit car hoods, boat hatches, RV compartments and bus panels where a hands-free lift is needed. Metal construction resists corrosion for long service life. Installation uses basic hand tools and the supplied 10mm ball sockets.

Sustained Force Under Repeated Cycles

Each strut maintains its 267N rating across full extension without pressure drop during normal opening and closing. The 15mm housing and 6mm rod keep alignment stable so the lid stays open at 27cm total length. Metal seals prevent gas loss over time, so the 60Lbs support remains consistent through daily use.

Verify Mounting Points and Weight Match

Confirm your application uses 10mm ball studs spaced for a 10.63cm centre-to-centre distance when closed. The lid or hatch must weigh within the 60Lbs per strut limit; heavier panels will not stay open. Check that the 3.54cm rod stroke clears surrounding brackets throughout the full travel. No special tools are required beyond a spanner for the ball sockets.

Highlights

  • Supports heavy lids with 60 lbs force per strut
  • Quick installation using only basic hand tools
  • White metal construction resists corrosion for long life
  • Universal fit for cars, boats, RVs and buses
  • 10 inch extended stroke gives ample hood clearance

Specifications

BrandUnique Bargains

Questions about this item

How much heat or noise does a 60 Lbs gas strut produce during all-day use?

A gas strut is a passive spring; it generates no heat, draws no power and makes no noise while holding a hood or hatch open.

What mounting hardware must I already have for the 10 mm hole and 6 mm rod to bolt on?

You need bolts or studs that match a 10 mm hole diameter and a 6 mm connecting-rod diameter on each end of the strut.

Will the 25.4 cm extended length and 15 mm housing diameter fit the same brackets as my old 10-inch struts?

Yes, if the original struts share the 25.4 cm extended length, 15 mm housing diameter and 10 mm hole spacing, these will bolt directly to the existing brackets.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.