We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Ten small brass V6 nozzles with M6 threads and stamped size markings

Unique-Bargains

Unique-Bargains 0.2mm Brass Nozzle V6 M6 1.75mm 10pcs

SKU CH-DJ9R-GWRH7

Pack of ten 0.2 mm brass V6 nozzles with M6 thread for 1.75 mm filament

  • 2 mm nozzle enables fine-detail prints
  • Brass construction suits PLA, ABS and PCL filaments
  • M6 thread fits V6 extruder heads directly
  • 75 mm filament compatibility for standard setups
  • Ten nozzles in one pack for quick replacements

0.2 mm Brass Nozzles for V6 Hotends

This pack contains ten brass nozzles with a 0.2 mm orifice, M6 thread and 7 mm thread length. They are designed for 1.75 mm filament and fit V6-style extruder heads. The brass construction suits non-abrasive materials such as PLA, ABS and PCL. Each nozzle is stamped with its size for quick identification.

Makers who want fine detail on V6 printers

The 0.2 mm bore suits users printing high-resolution models with standard filaments. Builders running abrasive composites such as carbon-fibre or glow-in-the-dark blends should look at hardened-steel alternatives. Printers that do not use a V6 hotend or M6 threading cannot accept these nozzles.

Check hotend compatibility and recalibration steps

Verify that your printer uses a V6 hotend with M6 threads before ordering. After installation, recalibrate the nozzle-to-bed distance to maintain print quality. Heat the block to the appropriate temperature range for your filament, then use a spanner to hold the block while swapping nozzles.

Highlights

  • 2 mm nozzle enables fine-detail prints
  • Brass construction suits PLA, ABS and PCL filaments
  • M6 thread fits V6 extruder heads directly
  • 75 mm filament compatibility for standard setups
  • Ten nozzles in one pack for quick replacements

Specifications

BrandUnique Bargains

Questions about this item

Will the 0.2mm nozzle thread directly into my V6 hot end with an M6 thread?

Yes, the nozzle uses an M6 thread with a 7mm thread length designed for V6 extruder heads.

Can I keep using my 1.75mm PLA and ABS spools with these brass nozzles?

Yes, the 0.2mm bore is made for 1.75mm filament and brass is suitable for non-abrasive materials such as PLA and ABS.

How do I verify the 0.2mm nozzles are printing correctly after installation?

Heat the hot end to 180-220 for PLA or 240-280 for ABS, then run a calibration print and check for consistent extrusion and proper first-layer adhesion.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.