Ubiquiti Networks
Ubiquiti Networks US-8-60W 8-Port Gigabit PoE Switch
An 8-port Gigabit managed switch with four 802.3af PoE ports, 60 W power budget and 8 Gbps non-blocking throughput
- 8 Gbps non-blocking throughput for full wire-speed traffic
- 4 auto-sensing IEEE 802.3af PoE ports power compatible devices directly
- UniFi application management simplifies network configuration and monitoring
- 60 W AC/DC adapter included delivers up to 12 W maximum switch consumption
- 16 Gbps switching capacity with 11.9 Mpps forwarding rate handles demanding loads
Ubiquiti 8-Port Gigabit PoE Switch
This managed switch provides eight Gigabit RJ45 ports, four of which support auto-sensing IEEE 802.3af PoE. It delivers 8 Gbps total non-blocking line rate with a 16 Gbps switching capacity and 11.9 Mpps forwarding rate. A 60 W AC/DC power adapter is included for deployment.
Suits small offices needing managed PoE for access
The four PoE ports share a 60 W budget managed via the UniFi application. Buyers needing PoE+ or 802.3at power levels should look elsewhere, as should anyone requiring more than four powered ports or a higher total PoE budget.
60 W PoE budget across four ports
The switch consumes up to 12 W itself, leaving the remainder for connected devices. This single power limit determines how many access points or cameras can run simultaneously without an external injector.
Highlights
- 8 Gbps non-blocking throughput for full wire-speed traffic
- 4 auto-sensing IEEE 802.3af PoE ports power compatible devices directly
- UniFi application management simplifies network configuration and monitoring
- 60 W AC/DC adapter included delivers up to 12 W maximum switch consumption
- 16 Gbps switching capacity with 11.9 Mpps forwarding rate handles demanding loads
Specifications
No published specifications for this item yet.
Questions about this item
What rack or desktop space does the US-8-60W need for mounting?
The switch is a compact desktop unit with eight Gigabit RJ45 ports; it sits on a shelf or can be wall-mounted using the built-in flange holes, requiring only a flat surface near a power outlet.
What is the step users often miss when adopting the switch into the UniFi controller?
After powering the unit with the included 60 W adapter, you must launch the UniFi application, discover the device on the same Layer 2 network, and click Adopt before any port or VLAN configuration will take effect.
Which part should be checked first if PoE devices stop receiving power while the switch stays online?
The external 60 W AC/DC power adapter supplies all PoE budget; verify its LED is lit and that the total draw of connected devices does not exceed the 60 W limit.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
