Tweco
Tweco M215-3035 MIG Gun 200 A 0.035 in 15 ft Miller
Air-cooled MIG gun rated 200 A at 60 % duty cycle, takes 0.035 in wire, 15 ft cable, Miller-compatible rear connection
- TypeWelding Parts & Supplies
- Air-cooled design suits 200 A MIG welding at 60 % duty cycle
- Handles 0.035 in solid or aluminium wire up to 200 A
- 15 ft cable with Miller-compatible rear connection fits existing leads
- Fixed 60° neck and straight handle give steady torch control
- Uses 14-series contact tips for quick tip changes
Air-cooled MIG gun for Miller
The Tweco M215-3035 is a 200 A air-cooled MIG gun built for Miller-compatible rear connections. It handles wire up to 0.035 in and comes with a 15 ft cable. The gun is rated at a 60 percent duty cycle for CO₂ shielding gas. A straight handle and fixed 60-degree neck complete the package.
Suits light fabrication and maintenance
This gun fits welders running short-run MIG jobs on mild steel or aluminium with solid wire. The 200 A ceiling and 60 percent duty cycle limit it to intermittent use. Shops needing continuous high-amperage output or water-cooled cooling should look elsewhere.
200 A maximum current at 60 percent duty cycle
The 200 A rating at 60 percent duty cycle is the decisive figure. It defines the amperage ceiling and the on-time window before the gun must cool. Match this number to your welder’s output and your typical weld length to confirm the gun will not overheat.
Highlights
- Air-cooled design suits 200 A MIG welding at 60 % duty cycle
- Handles 0.035 in solid or aluminium wire up to 200 A
- 15 ft cable with Miller-compatible rear connection fits existing leads
- Fixed 60° neck and straight handle give steady torch control
- Uses 14-series contact tips for quick tip changes
Specifications
| Brand | TWECO |
|---|---|
| Type | Welding Parts & Supplies |
Questions about this item
Does the Tweco M215-3035 come with contact tips or a liner installed?
The gun uses Tip Series 14 contact tips; tips and liner are consumables typically purchased separately.
Is the 200 A 60 % duty cycle rating the deciding factor for choosing this gun over higher-capacity models?
Yes, the 200 A at 60 % duty cycle with CO2 suits light-to-medium fabrication; step up if you need continuous high-amperage output.
What does the 200 A 60 % duty cycle mean during a typical 15 ft welding job?
You can weld at 200 A for six minutes out of every ten; the remaining four minutes let the air-cooled cable cool down.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
