We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Blue cast iron pillow block bearing with set screw locking, double sealed radial ball insert, cylindrical bore 1 3/8 in

Tritan

Tritan UCP207-22 Pillow Block Bearing Cast Iron Set Screw Locking Ball Blue

SKU CH-J574-YQMA5

Cast-iron pillow block bearing with a 1 3/8 in cylindrical bore, double-sealed radial ball insert and set-screw locking for bolt-through mounting

  • TypeBearings, V-belts & Power Transmission Equipment
  • ColorBlue
  • Blue cast-iron housing resists corrosion
  • Double-sealed radial ball bearing keeps contaminants out
  • Pre-lubricated with grease for immediate installation
  • Fixed expansion design maintains shaft alignment
  • Operates reliably from -40 to 250 °F

Purpose-built bearing for shaft support

The Tritan UCP207-22 pillow block bearing provides a fixed mounting point for rotating shafts in industrial machinery. Its cast iron housing and alloy steel radial ball insert suit maintenance teams who need a ready-to-install unit for conveyor lines, fans or agricultural equipment.

Replaces worn or damaged fixed bearings

When an existing pillow block shows excessive play, seal failure or housing cracks, this unit restores alignment without redesigning the mounting pattern. The bolt-through base matches common centre-to-centre dimensions, so the swap is worthwhile whenever downtime must be kept to a single planned outage.

Runs within a wide temperature envelope

Double-sealed closures retain the factory grease fill from minus forty degrees Fahrenheit up to two hundred fifty degrees Fahrenheit. The fixed expansion type keeps axial position stable during continuous operation, while the cast iron housing dissipates heat evenly across the base.

Highlights

  • Blue cast-iron housing resists corrosion
  • Double-sealed radial ball bearing keeps contaminants out
  • Pre-lubricated with grease for immediate installation
  • Fixed expansion design maintains shaft alignment
  • Operates reliably from -40 to 250 °F

Specifications

BrandTRITAN
TypeBearings, V-belts & Power Transmission Equipment
ColorBlue

Questions about this item

What are the bolt-hole center-to-center dimensions for mounting the UCP207-22?

The mount holes are spaced 5 inches center-to-center both lengthwise and widthwise, so the base needs a 5-by-5-inch bolt pattern.

How do I secure the bearing onto a 1 3/8-inch shaft and what step is often missed?

Slide the insert onto the cylindrical bore, then tighten both set screws evenly; the step often missed is re-checking screw torque after the first run-in period.

When should the grease in this double-sealed bearing be replenished or the unit replaced?

Operating between -40 °F and 250 °F, the factory grease lasts the rated life; replace the unit if seals leak, noise increases or shaft play exceeds tolerance.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.