Tripp Lite
Tripp Lite N820-04M-TAA 4 m OM3 LC/LC 10/40 Gb fibre optic cable
A 4 m OM3 multimode fibre patch cable with LC/LC duplex connectors supporting 10/40 Gb Ethernet up to 300 m
- Supports 10/40 Gb Ethernet up to 300 m
- Laser-optimised OM3 fibre works with VCSEL sources
- Aqua OFNP jacket rated for plenum spaces
- Duplex LC connectors on both ends
- TAA-compliant for government procurement
4 m OM3 duplex cable for 10/40 Gb networks
This 4 metre OM3 multimode patch cable uses 50/125 micron fibre terminated with duplex LC connectors on both ends. It is rated for 10 and 40 gigabit Ethernet links up to 300 metres at 850 nm wavelength. The aqua jacket identifies the OM3 grade and suits laser-optimised VCSEL or LED sources in LAN, SAN and parallel interconnect deployments.
OFNP plenum jacket and LC connectors
The cable carries an OFNP rating so it can be routed through plenum spaces such as drop ceilings and raised floors without additional conduit. Duplex male LC connectors on each end provide a compact, keyed interface that clicks into standard transceivers and patch panels. The non-conductive plenum construction meets fire-safety requirements for in-building backbone runs.
Passive fibre with no power draw
As a passive optical cable it introduces no electrical load, generates no heat and produces no audible noise during operation. Signal loss is limited to the intrinsic attenuation of the 50/125 micron multimode glass at 850 nm. The assembly simply connects two LC ports and relies on the active transceivers at each end for all power and thermal management.
Highlights
- Supports 10/40 Gb Ethernet up to 300 m
- Laser-optimised OM3 fibre works with VCSEL sources
- Aqua OFNP jacket rated for plenum spaces
- Duplex LC connectors on both ends
- TAA-compliant for government procurement
Specifications
No published specifications for this item yet.
Questions about this item
What bandwidth does the OM3 multimode cable support over 300 metres?
The cable is rated for 10/40 Gb Ethernet applications up to 300 metres at 850 nm wavelength.
What connectors and jacket type are used on this 4 metre patch cable?
It has duplex male LC connectors on each end and an aqua OFNP plenum-rated jacket for fire-resistant installations.
How should the LC connectors be seated during installation to avoid signal loss?
Push each LC connector straight in until the latch clicks; angled insertion can leave the ferrule unseated and degrade performance.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



