Toshiba
Toshiba TLPLX10 projector lamp 210W
A 210 W replacement lamp module with bulb and housing pre-assembled for quick installation, rated for 1,000 hours of use
- TypeProjector Lamp
- Wattage210W
- Lamp Life1,000 Hrs.
- Ready-to-install module saves setup time
- 210W NSH bulb matches original brightness
- 1000-hour rated life extends replacement interval
- Manufactured to ISO 9001 quality standards
- Tested for beam performance and ignition reliability
Replacement Lamp for Toshiba Projectors
The Toshiba TLPLX10 is a new 210W projector lamp module supplied with a pre-assembled NSH bulb and housing. It is designed for owners of compatible Toshiba projectors who need a direct replacement when the original lamp reaches its rated life. The unit arrives ready to fit without additional assembly.
Upgrading from a Dim or Expired Lamp
This lamp replaces an original module that has dimmed significantly or shut down after its rated 1000 hours of use. The jump is worth it when image brightness no longer suits the viewing environment or when the projector signals a lamp warning. It restores the projector’s intended light output for continued presentations or home viewing.
Simple Module Swap with Quality Assurance
Installation consists of opening the projector’s lamp door, removing the old module, and inserting this pre-assembled unit until it seats firmly. Each lamp is built to ISO 9001 standards and tested for ignition, voltage, beam performance, and run-time. The most common issue is forgetting to reset the projector’s lamp-hour counter after fitting the new module.
Highlights
- Ready-to-install module saves setup time
- 210W NSH bulb matches original brightness
- 1000-hour rated life extends replacement interval
- Manufactured to ISO 9001 quality standards
- Tested for beam performance and ignition reliability
Specifications
| Type | Projector Lamp |
|---|---|
| Wattage | 210W |
| Lamp Life | 1,000 Hrs. |
Questions about this item
Does the TLPLX10 module include the housing so I can slide it straight into the projector?
Yes, the TLPLX10 comes as a fully assembled 210 W bulb inside its housing, so it fits directly into the projector without extra assembly.
What is the correct way to seat the lamp connector during installation?
Align the module with the guide rails, push firmly until the connector clicks into the socket, then secure the retaining screws before closing the lamp door.
When should I plan to replace the lamp based on its rated life?
The NSH 210 W bulb is rated for 1,000 hours; schedule a replacement when the projector’s hour counter approaches that figure or brightness noticeably drops.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



