Toshiba
Toshiba TLP-X11U projector lamp 210W 1000 Hrs
Replacement projector lamp module for Toshiba TLP-X11U with 210W NSH bulb and housing rated for 1000 hours
- TypeProjector Lamp
- Wattage210W
- Lamp Life1,000 Hrs.
- 210W NSH bulb delivers bright projection
- 1000-hour rated life supports extended use
- Fully assembled module enables quick installation
- OEM-grade lamp ensures reliable compatibility
- ISO 9001 manufacturing provides consistent quality
Ready-to-install lamp module
The Toshiba TLP-X11U projector lamp arrives as a fully assembled 210W NSH bulb inside its housing, so it fits straight into compatible Toshiba projectors without extra assembly. It is intended for owners of those projectors who need a direct replacement when the original lamp reaches end of life.
ISO 9001 manufacturing quality
Each unit is produced to ISO 9001 standards and tested for beam performance, ignition, voltage, connections and run-time before shipping. The pre-fitted housing ensures correct alignment and secure mounting, reducing the risk of installation errors or loose connections during use.
OEM or compatible versions available
Depending on stock, the lamp ships as an OEM module from the original bulb manufacturer, the same OEM lamp sold by Toshiba, an alternative OEM source or a third-party compatible built with genuine OEM parts. All versions meet the same 1000-hour rated life and 210W specification.
Highlights
- 210W NSH bulb delivers bright projection
- 1000-hour rated life supports extended use
- Fully assembled module enables quick installation
- OEM-grade lamp ensures reliable compatibility
- ISO 9001 manufacturing provides consistent quality
Specifications
| Type | Projector Lamp |
|---|---|
| Wattage | 210W |
| Lamp Life | 1,000 Hrs. |
Questions about this item
What wattage does the 210W lamp draw, and what brightness limit does that set?
The lamp draws 210 watts, which caps the light output to the level the projector was designed for.
What housing dimensions and connector layout does the module use for the TLP-X11U?
The module matches the original TLPLX10 housing and connector so it seats in the projector without modification.
How is the lamp installed, and which step do users often miss?
Remove the old module, insert the new housing until it clicks, then reset the projector lamp counter to zero.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



