Toshiba
Toshiba TLP-X10E projector lamp 210W
A new 210 W projector lamp module with a 1,000-hour rated life, supplied as a fully assembled bulb and housing for direct installation
- TypeProjector Lamp
- Wattage210W
- Lamp Life1,000 Hrs.
- Ready to install with pre-assembled bulb and housing
- 210W NSH lamp matches original projector brightness
- 1000-hour rated life reduces replacement frequency
- Manufactured to ISO 9001 quality standards
- Tested for beam performance, ignition and voltage
Ready-to-install replacement lamp
This 210W NSH lamp module arrives fully assembled with housing for direct fit in compatible Toshiba projectors. It replaces the original TLPLX10 unit without extra tools or alignment steps. Rated life is 1,000 hours under normal operating conditions. Condition is new.
Suitable for owners needing a drop-in OEM-spec
Buyers who want a bare bulb without housing should look elsewhere. Users requiring longer rated life or different wattage will need another solution. The lamp is built to ISO9001 quality checks for ignition, voltage and run-time consistency.
Handles up to 1,000 hours of typical projection
At 210W it delivers the brightness the projector was designed for. Beyond the rated hours output will gradually decline and replacement becomes necessary. No other capacity or endurance figures apply.
Highlights
- Ready to install with pre-assembled bulb and housing
- 210W NSH lamp matches original projector brightness
- 1000-hour rated life reduces replacement frequency
- Manufactured to ISO 9001 quality standards
- Tested for beam performance, ignition and voltage
Specifications
| Type | Projector Lamp |
|---|---|
| Wattage | 210W |
| Lamp Life | 1,000 Hrs. |
Questions about this item
Which Toshiba projector models accept the TLP-X10E 210W lamp module?
The TLP-X10E lamp module is built for Toshiba projectors that specify the TLPLX10 part number; check your projector’s manual or the label inside the lamp door to confirm it lists TLP-X10E or TLPLX10 before ordering.
Will the 210W NSH bulb run in a projector that originally shipped with a lower-wattage lamp?
No; the projector’s ballast and cooling are matched to the original wattage, so a 210W lamp must only go into a model designed for 210W.
How can I verify the new lamp is performing correctly after installation?
Reset the lamp-hour counter in the projector menu, then confirm the image reaches full brightness without flicker and that the counter begins counting up from zero during normal use.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



