Toshiba
Toshiba TLP-X10 projector lamp 210W
Genuine replacement lamp module with 210W NSH bulb and housing rated for 1,000 hours
- TypeProjector Lamp
- Wattage210W
- Lamp Life1,000 Hrs.
- Genuine compatible replacement installs straight into Toshiba projectors
- 210 W NSH bulb delivers rated brightness
- 1,000-hour lamp life supports extended use
- Manufactured to ISO 9001 quality standards
- Ready-assembled housing enables quick tool-free swap
Genuine Replacement Projector Lamp Module
This Toshiba TLP-X10 lamp module arrives as a fully assembled 210W bulb inside its housing. It is designed for direct installation into compatible Toshiba projectors without extra assembly steps. The unit uses an NSH lamp type rated for 1,000 hours of operation. Buyers receive a new, ready-to-fit replacement part.
For Owners Needing a Direct-Fit 210W Lamp
This module suits users whose Toshiba projector specifies the TLP-X10 lamp and who want a complete housing for a straightforward swap. It is not intended for projectors that require a different wattage, a different lamp type, or a bare bulb without housing. Shoppers needing a longer-rated lifespan or a different connector layout should look elsewhere.
210W NSH Lamp Rated for 1,000 Hours
The lamp draws 210W and carries a 1,000-hour life rating under standard operating conditions. This single figure determines whether the module matches the projector's original specification. Verify that your device calls for a 210W NSH lamp with a 1,000-hour rating before purchasing.
Highlights
- Genuine compatible replacement installs straight into Toshiba projectors
- 210 W NSH bulb delivers rated brightness
- 1,000-hour lamp life supports extended use
- Manufactured to ISO 9001 quality standards
- Ready-assembled housing enables quick tool-free swap
Specifications
| Type | Projector Lamp |
|---|---|
| Wattage | 210W |
| Lamp Life | 1,000 Hrs. |
Questions about this item
Which Toshiba projectors accept the TLP-X10 lamp module?
The TLP-X10 lamp module is designed for Toshiba projectors that use the TLPLX10 part number; check your projector's manual to confirm it lists this module before ordering.
Can I reuse the existing housing and only replace the 210W NSH bulb?
This unit ships as a fully assembled 210W NSH bulb inside a new housing, so the complete module is swapped in one step; no separate bulb-only installation is required.
How do I verify the lamp is operating correctly after installation?
After fitting the module, reset the projector's lamp-hour counter; the counter should start from zero and the image should reach full brightness without flickering during the first 10 minutes of use.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



