We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Toshiba TLP-LT3 projector lamp module with 270W bulb in housing

Toshiba

Toshiba TLP-LT3 projector lamp 270W 2000 Hrs

SKU CH-KEFK-AVC2V

A 270W replacement lamp module with 2,000-hour rated life, supplied as a pre-assembled bulb and housing for quick installation

  • TypeProjector Lamp
  • Wattage270W
  • Lamp Life2,000 Hrs.
  • Ready-to-install module with bulb and housing
  • 270W Phoenix SHP bulb delivers specified brightness
  • 2000-hour rated lamp life for extended use
  • Manufactured to ISO9001 quality standards
  • Tested for beam performance, ignition and run-time

Ready-to-install replacement module

The Toshiba TLP-LT3 lamp ships as a fully assembled 270W bulb inside its housing so you can swap it in without tools or alignment steps. It is built for A&K projectors that specify the TLP-LT3 part number and is supplied new in manufacturer-sealed packaging. The module uses a Phoenix SHP bulb selected for consistent ignition and stable voltage across its rated life.

270W output rated for 2000 hours

At the rated 270W the lamp delivers full brightness for approximately 2000 hours before light output drops to the level where a replacement is normally scheduled. Running the projector in eco or low-power modes will extend that interval, while continuous high-brightness operation in warm environments will shorten it. The 270W draw also defines the thermal load your projector’s cooling system must handle.

OEM-grade bulb with ISO 9001 quality checks

Each unit passes beam-performance, ignition, voltage, appearance, connection and run-time tests under an ISO 9001 quality system before it leaves the factory. The Phoenix SHP bulb is sourced from the same tier-one suppliers that furnish original-equipment lamps, so colour balance and focus stability match the projector’s factory calibration. No additional software, firmware or accessories are included in the package.

Highlights

  • Ready-to-install module with bulb and housing
  • 270W Phoenix SHP bulb delivers specified brightness
  • 2000-hour rated lamp life for extended use
  • Manufactured to ISO9001 quality standards
  • Tested for beam performance, ignition and run-time

Specifications

BrandA&K
TypeProjector Lamp
Wattage270W
Lamp Life2,000 Hrs.

Questions about this item

Will this 270 W Phoenix SHP lamp module fit the same housing my A&K projector already uses?

Yes — the unit ships as a fully assembled bulb and housing designed for direct replacement in the A&K projector that originally used the TLP-LT3 lamp.

How can I confirm the new lamp is performing correctly once installed?

Reset the projector's lamp-hour counter, then verify the image reaches full brightness without flicker and the counter begins advancing from zero.

Does the package include only the lamp module or are extra cables or tools required?

The box contains the complete 270 W Phoenix SHP bulb-and-housing module; no additional cables, tools or separate housings are needed for installation.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.