Toshiba
Toshiba TLP-B2 Ultra E Genuine Compatible 120W Projector Lamp
A ready-to-install 120 W replacement lamp module rated for 2,000 hours of use
- TypeProjector Lamp
- Wattage120W
- Lamp Life2,000 Hrs.
- Ready to install with pre-assembled bulb and housing
- 120W UHP lamp delivers bright projection
- 2,000 hours rated lamp life for extended use
- Manufactured to ISO9001 quality standards
- Tested for beam performance, ignition and run-time
120W UHP Projector Lamp
The Toshiba TLP-B2 Ultra E is a genuine compatible replacement lamp module supplied new. It arrives as a fully assembled 120W UHP bulb inside its housing, ready for direct installation into a Toshiba projector. This unit is intended for owners of a compatible Toshiba model who need to restore original brightness after the previous lamp reaches end of life.
Suitable for Toshiba projector owners
This lamp suits users who want a drop-in 120W module that matches the projector’s original specifications without extra assembly. It is not for buyers who need a bare bulb only, nor for anyone whose projector requires a different wattage or connector type. If your device calls for another lamp code, this module will not fit.
Rated 2,000 hours lamp life
The manufacturer rates this lamp at 2,000 hours of operation under standard conditions. That figure is the primary specification to verify against your projector’s requirements and your expected usage patterns before purchase.
Highlights
- Ready to install with pre-assembled bulb and housing
- 120W UHP lamp delivers bright projection
- 2,000 hours rated lamp life for extended use
- Manufactured to ISO9001 quality standards
- Tested for beam performance, ignition and run-time
Specifications
| Type | Projector Lamp |
|---|---|
| Wattage | 120W |
| Lamp Life | 2,000 Hrs. |
Questions about this item
Which Toshiba projector models accept the TLP-B2 Ultra E lamp with its 120W UHP bulb?
This lamp module is built for Toshiba projectors that specify the TLP-B2 Ultra E part number TLPLB2P; check your projector’s manual for that exact model reference before ordering.
Can I reuse the existing lamp housing from my old TLP-B2 unit instead of installing the new housing supplied?
The replacement arrives as a complete 120W bulb-and-housing assembly, so the old housing is not needed and should be recycled according to local guidelines.
How do I verify the new lamp is operating correctly once installed?
Reset the projector’s lamp-hour counter, then confirm the on-screen timer begins counting from zero and the image reaches full brightness without flicker during the first 2,000-hour rated life.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



