We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Red and black 1/0 gauge cable kit with fuse holder, RCA and speaker wires, terminals and zip ties

The Wires Zone

The Wires Zone 1/0 Gauge Amplifier Install Kit

SKU CH-CB9S-MYTP1

Complete 1/0-gauge amplifier wiring kit with 17 ft power, ground, RCA, speaker and remote cables plus a 150 A ANL fuse holder

  • TypeAmplifier Installation Kits
  • Complete amp install kit with all cables included
  • 150A ANL fuse protects the power circuit
  • 17ft flexible power cable reaches battery easily
  • 17ft RCA cable carries clean signal to amp
  • 10 zip ties and split loom secure every run

Complete Amplifier Wiring Kit

This 1/0-gauge kit supplies every cable and connector needed to install an aftermarket amplifier in a vehicle. It includes power, ground, remote turn-on, RCA and speaker wires plus a fuse holder and terminals. The super-flexible conductors simplify routing through tight interior spaces. Ideal for installers who want a single package with all essential components.

Upgrade From Thinner Gauge Kits

The 1/0-gauge conductors replace smaller 4-gauge or 8-gauge kits when an amplifier demands higher current capacity. The 150A ANL fuse protects the system during high-output operation. The jump is worth it when your amplifier's power requirements exceed what thinner wiring can safely deliver without voltage drop or overheating.

Verify Amplifier Power And Cable Lengths

Check that your amplifier's maximum current draw stays within the 150A fuse rating before ordering. Confirm the 17ft power and RCA runs reach your battery and head-unit locations without splicing. Ensure the 3ft ground cable can reach a clean chassis point near the amplifier mounting position.

Highlights

  • Complete amp install kit with all cables included
  • 150A ANL fuse protects the power circuit
  • 17ft flexible power cable reaches battery easily
  • 17ft RCA cable carries clean signal to amp
  • 10 zip ties and split loom secure every run

Specifications

TypeAmplifier Installation Kits

Questions about this item

How much space do I need to route the 17 ft power cable and 17 ft RCA cable from the battery to the amplifier location?

The 17 ft power cable and 17 ft RCA cable are each 17 ft long, so measure the full path from the battery through the firewall and interior to the amp mount point; the included 1/0 gauge split loom and ten 4-inch zip ties help bundle and secure both runs along that route.

What is the correct order for connecting the 150 A ANL fuse holder to the 17 ft power cable so the fuse protects the amplifier?

Crimp a supplied 1/0 gauge ring terminal onto the power cable at the battery end, attach that terminal to the battery positive post, then insert the in-line ANL fuse holder into the cable within 18 inches of the battery before routing the remaining length to the amplifier.

When should I inspect or replace the 150 A ANL fuse and the 17 ft CCA power and ground cables?

Check the 150 A ANL fuse visually after any amplifier fault or blown-fuse event and replace it only with another 150 A ANL fuse; inspect the 17 ft CCA power and ground cables annually for corrosion at the ring terminals or damage to the split loom, replacing any section that shows green oxidation or cracked insulation.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.