The Install Bay IBR116 USB 3.0 Charge and Data Flush Mount car electronics accessory

Single USB-A 3.0 port for vehicle integration

This accessory adds a single USB-A 3.0 connection for charging and data transfer in a car. It is designed for drivers who want a permanent, factory-look interface at the dashboard. The unit suits installations where only one USB port is required. It is not for buyers who want multiple ports or a different connector type.

Sustained data and power delivery through 1 m cable

The 1 m (3 ft) lead connects the port to the source device, maintaining the USB 3.0 signal over the full length. Performance under continuous use depends on the host controller and cable quality, not on the mount itself. The flush-mount body simply passes through the signals and power supplied by the vehicle harness. It is not for installers who need active signal boosting or longer runs without a repeater.

USB 3.0 practical limits in a 26 mm flush mount

The 26 mm cut-out accepts the port housing, while the included surface-mount adapter and water-resistant cover offer alternative fitting options. USB 3.0 bandwidth and current are constrained by the host and cable, not by the mounting hardware. The accessory adds no protocol conversion or power negotiation. It is not for applications that require a sealed bulkhead connector rated beyond the supplied cover.