We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in

THE CIMPLE CO

THE CIMPLE CO Solid Copper Coax Cable 150 Foot Black RG6 2 in 1 accessory

SKU CH-4CTW-K9989

150-foot RG6 coaxial cable with solid copper core, 75-ohm impedance and UV-resistant jacket for indoor or outdoor signal runs up to 3.0 GHz

  • Solid copper conductor delivers clear signals over long runs
  • UV-coated PVC jacket and double O-ring connectors withstand indoor and outdoor exposure
  • Swept to 3.0 GHz for reliable high-speed digital and analog transmission
  • 18 AWG center conductor with aluminum braiding and shielding prevents interference
  • 150 foot length with 2-foot markings simplifies custom installations

150-Foot RG6 Coaxial Cable

This 150-foot RG6 coaxial cable delivers a low-loss signal path for long-distance runs. It uses an 18 AWG solid copper center conductor with aluminum braiding and shielding to maintain signal integrity. The cable is swept to 3.0 GHz and supports frequencies from 2.3 MHz for both digital and analog systems. Precision-machined connectors ensure a secure, weather-tight connection.

Upgrade from Thinner or Damaged Coax

Replacing older, higher-loss cables or damaged runs restores signal quality for cable modems, satellite receivers and antennas. The jump is worth it when existing wiring causes pixelation, dropped internet sync or weak antenna reception over distance. Double O-ring compression connectors and a UV-coated PVC jacket add durability that basic cables lack. Length markings every two feet simplify measuring during installation.

Check Connector Type and Run Length

Verify that your devices use F-type female ports before ordering. Confirm the 150-foot length matches the exact path from source to destination, including slack for routing. Ensure outdoor entry points allow the 360-degree compression connectors to seat fully for a moisture seal. The 75-ohm impedance suits standard CATV, satellite and antenna systems.

Highlights

  • Solid copper conductor delivers clear signals over long runs
  • UV-coated PVC jacket and double O-ring connectors withstand indoor and outdoor exposure
  • Swept to 3.0 GHz for reliable high-speed digital and analog transmission
  • 18 AWG center conductor with aluminum braiding and shielding prevents interference
  • 150 foot length with 2-foot markings simplifies custom installations

Specifications

No published specifications for this item yet.

Questions about this item

What diameter hole does the 18 AWG solid copper center conductor and PVC jacket need to pass through?

The cable uses an 18 AWG solid copper center conductor with a PVC outer jacket; drill a hole slightly larger than the jacket diameter to avoid kinking the 150 foot run.

How do I attach the F-type compression connectors without crushing the double O-ring weather seal?

Strip the jacket and braid to expose the 18 AWG center conductor, seat the connector fully, then compress with a 360 degree tool until the double O-ring seats — do not over-tighten.

When should I replace the UV-coated connectors on a 150 foot outdoor run?

Inspect the UV-coated connectors annually; replace them if the PVC jacket cracks, the double O-ring loses elasticity, or signal loss rises above the 3.0 GHz sweep rating.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.