Tenda
Tenda OS3 KIT 5 GHz 867 Mbit/s outdoor access point
Outdoor 5 GHz 867 Mbit/s CPE kit with 12 dBi antenna, 3.1 mile range, IP65 housing, Fast Ethernet port and pole or wall mounting
- Outdoor Wi-Fi up to 3.1 miles with 12 dBi directional antennas
- 5 GHz 867 Mbit/s link for high-throughput point-to-point connections
- IP65 weatherproof housing withstands rain and dust in permanent installations
- Pole or wall mounting hardware included for flexible site deployment
- Low 4.70 W draw enables passive PoE or solar-powered operation
Outdoor 5 GHz link kit
The Tenda OS3 KIT delivers a 5 GHz outdoor wireless link rated at 867 Mbit/s for point-to-point or point-to-multipoint deployments. It targets installers and small-business owners who need a ready-to-mount pair for extending a network between buildings.
IP65 enclosure with pole or wall mounting
The IP65-rated housing resists dust and water jets, allowing permanent installation on a mast or façade. A single Fast Ethernet RJ-45 port carries data and power at 4.70 W, so one outdoor-rated cable handles both connections.
Check PoE injector and cable length before ordering
The kit requires a compatible passive PoE source; verify your injector or switch port supplies the correct voltage. Ensure the Ethernet run stays within standard limits and that a clear line of sight exists for the stated 3.1 mile range.
Highlights
- Outdoor Wi-Fi up to 3.1 miles with 12 dBi directional antennas
- 5 GHz 867 Mbit/s link for high-throughput point-to-point connections
- IP65 weatherproof housing withstands rain and dust in permanent installations
- Pole or wall mounting hardware included for flexible site deployment
- Low 4.70 W draw enables passive PoE or solar-powered operation
Specifications
| Brand | Tenda |
|---|---|
| Shipping weight | 1.10 kg |
| Package size | 292 × 241 × 102 mm |
Questions about this item
What wireless standard and frequency does the 867 Mbit/s rating apply to?
The 867 Mbit/s rate is for the 5 GHz band using the IEEE 802.11a/n/ac standards supported by this kit.
What mounting hardware is required for the IP65-rated enclosure?
The kit includes brackets for pole-mount and wall-mount installation; no extra hardware is needed for standard poles or flat surfaces.
How do I power the units during installation?
Connect the included PoE injector to a mains outlet, then run a single Ethernet cable from the injector LAN port to the unit’s RJ-45 port for both data and power.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



