Tempco
Tempco CSH00179 Strip Heater 23-3/4 in 120V 750W
120 V strip heater, 23 3/4 in long, delivers 750 W with 11 W/sq in density and 304 stainless sheath
- ColorAmber
- 750 W output for strong heating
- 120 V single-phase fits standard supply
- 304 stainless sheath resists corrosion
- CSA and cURus listed for safety
- 23-3/4 in length suits surface mounting
Industrial Strip Heater 120V 750W
The Tempco CSH00179 is a surface-mount strip heater designed for industrial process heating. It operates at 120 volts and delivers 750 watts with a watt density of 11 W/sq in. The unit reaches a maximum sheath temperature of 1200 degrees F. It suits applications requiring consistent radiant heat in manufacturing or packaging equipment.
Surface Mount With Slotted Holes
Installation uses two slotted mounting holes measuring 1/2 in by 5/16 in for flexible alignment on flat surfaces. The overall length is 23 3/4 in with a mounting dimension of 22 3/4 in. Terminals are arranged in parallel and accept 10-32 screws for secure wiring. Misalignment of the slotted holes or over-tightening the terminal screws can damage the stainless steel sheath.
Single Phase 120V CSA cURus NRTL
The heater runs on single-phase 120V power and carries CSA, cURus and NRTL certifications under UL 499 and Canadian Standard C22.2 No 72. The 304 seamless stainless steel sheath resists oxidation up to the rated temperature limit. It is not suited for three-phase systems, voltages above 120V or environments exceeding the 1200 degree F sheath rating.
Highlights
- 750 W output for strong heating
- 120 V single-phase fits standard supply
- 304 stainless sheath resists corrosion
- CSA and cURus listed for safety
- 23-3/4 in length suits surface mounting
Specifications
| Brand | TEMPCO |
|---|---|
| Color | Amber |
Questions about this item
How can I verify the heater is reaching its rated 1,200 °F sheath temperature after installation?
Measure the sheath surface with a calibrated infrared thermometer or contact probe while the unit runs at 120 V; the reading should approach 1,200 °F under normal load.
What components are included and what must I source separately for a surface-mount installation?
The strip heater body with parallel terminals and slotted mounting holes is supplied; you must provide 10-32 screws, wiring rated for 750 W at 120 V, and a suitable temperature controller.
Which voltage and wattage version should I select for a 120 V single-phase circuit needing roughly 750 W?
Choose the 120 V, 750 W model (CSH00179) — it delivers 11 W/sq in on a 23-3/4 in sheath and is UL recognised for 120 V single-phase operation.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
