Tempco
Tempco BCH06429 Band Heater 2 in 240V 1400 Deg F
A 240 V ceramic-fibre band heater with 1 000 W output and 33 W/sq in density for temperatures up to 1 400 °F
- Heats to 1400 °F for demanding thermal processes
- 1000 W output delivers concentrated 33 W/sq in power density
- Ceramic fiber construction withstands extreme continuous temperatures
- 240 V supply with 4.17 A draw fits standard industrial circuits
- 10/32 screw terminals enable secure, tool-friendly wiring
Tempco BCH06429 Band Heater for industrial use
This ceramic-fibre band heater delivers 1,000 W at 240 V for processes that need up to 1,400 °F. The 2 in width and 5 in inside diameter fit standard cylindrical vessels. Opposite-side 10/32 screw terminals simplify wiring in tight enclosures.
Suits continuous high-temperature heating.
The 33 W/sq in watt density and 4.17 A draw serve steady-state thermal applications. Buyers who need a lower maximum temperature or a different voltage should look at other models. The fixed 2 in width and 5 in bore limit use to matching geometries.
Maintains rated output during extended cycles
Ceramic-fibre insulation sustains 1,400 °F without rapid degradation under constant load. The screw-terminal design resists loosening from thermal expansion over long runs. Steady 1,000 W output is preserved when the heater is clamped securely to the work surface.
Highlights
- Heats to 1400 °F for demanding thermal processes
- 1000 W output delivers concentrated 33 W/sq in power density
- Ceramic fiber construction withstands extreme continuous temperatures
- 240 V supply with 4.17 A draw fits standard industrial circuits
- 10/32 screw terminals enable secure, tool-friendly wiring
Specifications
| Brand | TEMPCO |
|---|
Questions about this item
What pipe diameter is required for the 5 in inside diameter band heater to fit?
The band heater is designed for a 5 in inside diameter, so the pipe or cylinder must match that size for proper contact.
Can the 10/32 screw terminals connect to standard 10 AWG wiring used on older controllers?
Yes, the 10/32 screw terminals accept standard ring or fork terminals crimped to 10 AWG or smaller conductors.
How do I verify the heater reaches its 1400 Degrees F rating after installation?
Measure the surface temperature with a calibrated infrared thermometer or contact probe while the unit draws 4.17 A at 240V.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
