Telemecanique Sensors
Telemecanique Sensors XZCPV1965L2 Cordset 2 m Yellow 4 A 18 AWG IP65 IP67
A yellow PVC cordset with a right-angle female connector and bare-wire end, rated 4 A at 18 AWG and sealed to IP65 and IP67
- Right-angle female connector with 1/2 in.-20 thread eases panel mounting
- 2 m yellow PVC jacket resists oil and abrasion in harsh environments
- IP65 and IP67 ratings protect against dust and water ingress
- 4 A at 18 AWG handles control-circuit loads reliably
- CSA, IEC and UL listings confirm safety compliance
Industrial Cordset 2 m Yellow 4 A
The Telemecanique Sensors XZCPV1965L2 cordset provides a 2 metre yellow PVC cable rated for 4 A at 18 AWG. It terminates in a right-angle female connector with 1/2 in. -20 threads and three pins on one end, with bare wires on the other for direct termination.
Capacity and Headroom 250 VAC 300 VDC IP65 IP67
The cable carries up to 250 VAC or 300 VDC and operates from -13 °F to 176 °F, giving headroom for typical sensor and actuator circuits in harsh environments. Its IP65 and IP67 ratings protect against dust ingress and temporary immersion, but the 4 A limit means it cannot serve higher-power motor feeds.
Build Quality CSA UL IEC Connectors
The assembly meets CSA, UL and IEC standards, with a PVC jacket that resists oil and abrasion in machine-shop conditions. The right-angle mounting orientation reduces cable strain in tight enclosures, while the bare-wire end allows flexible field wiring without additional connectors.
Highlights
- Right-angle female connector with 1/2 in.-20 thread eases panel mounting
- 2 m yellow PVC jacket resists oil and abrasion in harsh environments
- IP65 and IP67 ratings protect against dust and water ingress
- 4 A at 18 AWG handles control-circuit loads reliably
- CSA, IEC and UL listings confirm safety compliance
Specifications
| Brand | TELEMECANIQUE SENSORS |
|---|
Questions about this item
Will the 1/2 in -20 thread on the female end mate with my existing sensor ports?
The cordset has a right-angle female connector with a 1/2 in -20 thread and three pins, matching common sensor ports that use the same thread size and pin count.
How can I verify the IP65 and IP67 seals are effective after installation?
Inspect the yellow PVC jacket for damage, ensure the right-angle connector seats fully on the 1/2 in -20 thread, and confirm no moisture enters the three-pin interface during a low-pressure wash-down test.
Does the 2 m yellow PVC cordset arrive with both ends terminated or must I crimp the bare-wire end myself?
End 1 is a pre-wired right-angle female connector; End 2 is bare wire, so you will need to terminate or connect those conductors to your control circuit.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
