Telemecanique Sensors
Telemecanique Sensors XS630B1NAL2 Inductive Proximity Sensor 30mm NPN NO
A 30 mm shielded inductive sensor detects metal up to 15 mm away with a 500 Hz switching rate and NPN normally-open output
- Detects metal at 15 mm for reliable positioning
- 12–48 V DC supply fits common control voltages
- 500 Hz switching handles fast production cycles
- IP68 and IP69K sealing survives wash-down and immersion
- Nickel-plated brass body resists corrosion in harsh environments
Industrial Proximity Sensor
The Telemecanique Sensors XS630B1NAL2 is a shielded inductive proximity sensor built for industrial automation. It detects metal targets at distances up to 15 mm using a 30 mm diameter barrel. The unit operates on 12 to 48V DC power and switches a 3-wire NPN normally open output at 500 Hz. It suits machine builders and maintenance teams needing reliable presence detection.
Sealed Cable Connection
A fixed 2 m cable provides the electrical connection without separate plugs or sockets. This reduces potential failure points from vibration or moisture ingress at the connector interface. The cable exits the nickel-plated brass housing directly, simplifying installation in tight cable trays or conduit runs where bulkhead connectors would add bulk.
Harsh Environment Build
The sensor carries IP68 and IP69K ratings alongside a NEMA 4X enclosure rating, confirming protection against prolonged immersion and high-pressure washdown. Nickel-plated brass construction resists corrosion from coolants and cleaning agents. An operating range of -13 to 158 degrees Fahrenheit allows use in unheated facilities or near hot processes without derating.
Highlights
- Detects metal at 15 mm for reliable positioning
- 12–48 V DC supply fits common control voltages
- 500 Hz switching handles fast production cycles
- IP68 and IP69K sealing survives wash-down and immersion
- Nickel-plated brass body resists corrosion in harsh environments
Specifications
| Brand | TELEMECANIQUE SENSORS |
|---|
Questions about this item
How often should the 2 m cable on the XS630B1NAL2 be inspected or replaced?
The 2 m cable is a fixed part of the sensor; inspect it periodically for cuts or abrasion and replace the whole unit if the jacket is damaged.
At 500 Hz switching, what is the first limit reached during continuous operation?
The 200 mA maximum load current is the limiting factor; exceeding it will trip the output before frequency becomes an issue.
How much heat does the sensor generate when running all day at 48 V DC?
Power dissipation stays low because the sensor only draws up to 200 mA at 12–48 V DC, and the nickel-plated brass housing conducts heat away effectively.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
