Telemecanique Sensors
Telemecanique Sensors XS130BLPAM12 Inductive Proximity Sensor 30mm PNP NO
Detects metal objects up to 10 mm away with a shielded 30 mm barrel, 12 to 24 V DC supply, PNP normally-open output and IP67-rated nickel-plated brass housing
- Detects metal targets up to 10 mm away
- Operates on 12 to 24 V DC supply
- 200 Hz switching frequency for fast response
- IP67 and NEMA 4X ratings resist water and dust
- Nickel-plated brass housing withstands -13 °F to 158 °F
Product Identity
The Telemecanique Sensors XS130BLPAM12 is an inductive cylindrical proximity sensor built for industrial detection tasks. It operates on 12 to 24V DC supply voltage and provides a PNP normally-open output through a 4-pin M12 connector. The shielded 30 mm brass housing carries NEMA 4X and IP67 ratings for harsh environments.
Target User
This sensor suits automation engineers who need reliable metal detection at 10 mm range with a 200 Hz switching frequency. The 100 mA maximum load fits standard PLC inputs and small actuators. Buyers requiring longer sensing distances, NPN logic, or normally-closed output logic should look at alternative models.
Connection Benefit
The 4-pin M12 connector enables quick plug-in installation without field wiring to screw terminals. Nickel-plated brass construction resists coolant and wash-down exposure across a -13 to 158 degrees F operating range. The 41 mm overall length fits standard mounting brackets for 30 mm sensors.
Highlights
- Detects metal targets up to 10 mm away
- Operates on 12 to 24 V DC supply
- 200 Hz switching frequency for fast response
- IP67 and NEMA 4X ratings resist water and dust
- Nickel-plated brass housing withstands -13 °F to 158 °F
Specifications
| Brand | TELEMECANIQUE SENSORS |
|---|
Questions about this item
What power supply voltage does the 30 mm inductive sensor require?
The sensor operates on 12 to 24 V DC, so a compatible DC supply within that range must already be available.
Will the 4-pin M12 connector on this sensor mate with my existing M12 cable?
Yes, the 4-pin M12 connector follows the standard pinout, so it will connect directly to existing M12 cables wired for 3-wire PNP sensors.
How can I verify the sensor is detecting at the rated 10 mm distance after installation?
Bring a standard steel target to 10 mm from the sensing face; the PNP NO output should switch high, and the LED indicator (if present) will illuminate.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
