We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Green rectangular circuit board with 44 pin male IDE connector and 22 pin female SATA connector

TeKit

TeKit SATA to IDE 2.5" Adapter 44 Pin Male 22 Pin SATA Green

SKU CH-PNCS-65SJJ

Connects a 2.5" SATA drive to a 44-pin IDE laptop port for drive upgrades without extra cables or drivers

  • ColorGreen
  • Changer TypeSATA to IDE Laptop Adapter, Convert 2.5 Inch Serial ATA HDD
  • SpecificationsSATA to IDE Laptop Adapter, Convert 2.5 Inch Serial ATA HDD
  • FeaturesSATA to IDE Laptop Adapter, Convert 2.5 Inch Serial ATA HDD
  • Package Contents1pc
  • Upgrade older laptops with modern 2.5 SATA drives using the 44 pin IDE interface
  • Power the drive directly from the 44 pin IDE connector without extra cables
  • Plug and play installation requires no drivers for immediate use
  • Supports IDE transfer rates of 66 100 and 133 MB/s for broad compatibility
  • Compact 2.72 x .55 x .69 inch board fits tight laptop bays

SATA-to-IDE adapter for 2.5" drives

This green adapter converts a 2.5 inch SATA hard drive or SSD to a 44 pin male IDE connector. It draws power directly from the 44 pin IDE port so no extra cables are required. The board measures 2.72 by .55 by .69 inches. Condition is new.

Bundled adapter only

The package contains one 22 pin SATA to IDE 2.5 male horizontal adapter and nothing else. No driver installation is needed because the device operates plug and play. Hot swapping is not supported by this design.

Suits legacy laptop upgrades

Users upgrading older laptops that only accept 44 pin IDE 2.5 inch drives can install modern SATA storage up to 500 GB. Builders needing hot-swap capability or larger drive support should look elsewhere.

Highlights

  • Upgrade older laptops with modern 2.5 SATA drives using the 44 pin IDE interface
  • Power the drive directly from the 44 pin IDE connector without extra cables
  • Plug and play installation requires no drivers for immediate use
  • Supports IDE transfer rates of 66 100 and 133 MB/s for broad compatibility
  • Compact 2.72 x .55 x .69 inch board fits tight laptop bays

Specifications

BrandTekit
ColorGreen
Changer TypeSATA to IDE Laptop Adapter, Convert 2.5 Inch Serial ATA HDD Hard Disk Drive or SSD to 44 Pin Male PATA Port (Parallel Type)
SpecificationsSATA to IDE Laptop Adapter, Convert 2.5 Inch Serial ATA HDD Hard Disk Drive or SSD to 44 Pin Male PATA Port (Parallel Type)
FeaturesSATA to IDE Laptop Adapter, Convert 2.5 Inch Serial ATA HDD Hard Disk Drive or SSD to 44 Pin Male PATA Port (Parallel Type)
Package Contents1pc

Questions about this item

Will the 44-pin IDE connector wear out from repeated drive swaps?

The 44-pin male IDE connector is rated for standard mating cycles; avoid frequent insertion and removal to maintain reliable contact.

Does the bridge board throttle at sustained IDE 133 MB/s transfers?

The adapter supports IDE 66, 100 and 133 MB/s modes; sustained throughput will be limited by the drive and host controller rather than the bridge.

Does the adapter draw extra power from the 44-pin IDE port during all-day operation?

Power is supplied entirely through the 44-pin IDE connector; the board adds no separate power requirement and runs without active cooling.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.