TeKit
TeKit Dual PSU ATX 24-Pin 20+4 Male to 2×24 Female Splitter 30 cm 2000 W 18 AWG
Connects two PSUs to one motherboard for simultaneous start-up and up to 2000 W total power
- TypeCable Connectors
- ColorBlack
- Length1 Foot
- Cable Length1 ft.
- SpecificationsATX 24-Pin 20+4Pin Dual PSU Power Supply Extension Cable Syn
- Connector A24PIN(20+4) Male
- Powers two PSUs from one motherboard with a single 24-pin male connector
- Supports up to 2000 W total load across both power supplies
- 18 AWG conductors handle high current for stable GPU mining operation
- 30 cm length keeps cable routing tidy inside compact cases
- Works with both 20-pin and 24-pin ATX motherboards for broad compatibility
Dual PSU splitter for multi-GPU builds
This 30 cm ATX 24-pin 20+4 male to dual 24-pin female cable lets a single motherboard start two power supplies at the same time. It is intended for miners and enthusiasts who need more GPU power than one unit can deliver. The 18 AWG conductors are rated for a combined 2000 W load. No extra motherboard or relay board is required.
Synchronous start-up under continuous load
Both PSUs receive the power-on signal together so rails rise in unison, avoiding the voltage dip that can crash a mining rig or heavy compute workload. The short 1-foot length keeps resistance low while the 18 AWG wires handle sustained current without overheating. Builders must verify that each supply supports zero-load operation before relying on the splitter.
2000 W combined rating decides fit
The 2000 W ceiling is the single figure that determines whether this adapter suits your build; exceeding it risks melted connectors or shutdowns. Check the wattage of both units against that limit before purchase. The cable works with any mix of 20-pin or 24-pin ATX supplies but cannot compensate for a supply that refuses to start without a minimum load.
Highlights
- Powers two PSUs from one motherboard with a single 24-pin male connector
- Supports up to 2000 W total load across both power supplies
- 18 AWG conductors handle high current for stable GPU mining operation
- 30 cm length keeps cable routing tidy inside compact cases
- Works with both 20-pin and 24-pin ATX motherboards for broad compatibility
Specifications
| Brand | Tekit |
|---|---|
| Type | Cable Connectors |
| Color | Black |
| Length | 1 Foot |
| Cable Length | 1 ft. |
| Specifications | ATX 24-Pin 20+4Pin Dual PSU Power Supply Extension Cable Synchronous Connector Cord Cable |
| Connector A | 24PIN(20+4) Male |
| Connector B | 2X 24PIN Female |
| Connector Number | 3 |
| Terminal Gender | Male to Female |
| Features | ATX 24-Pin 20+4Pin Dual PSU Power Supply Extension Cable Synchronous Connector Cord Cable |
| Style | 1-Pack |
Questions about this item
Will the 18 AWG wiring and 30 cm length handle continuous 2000 W loads without excessive heat?
The splitter uses 18 AWG conductors rated for up to 2000 W total, and the short 30 cm run keeps resistance low so heat stays minimal during all-day operation.
My motherboard has a 20-pin ATX socket — can I still use this splitter?
Yes, the male connector is a 20+4 pin design that fits both 24-pin and 20-pin motherboard headers, so no extra adapter is needed.
Can I pair a modern PSU with an older unit that lacks zero-load support?
The cable simply bridges the ATX-on signal; both supplies must be capable of starting without a minimum load, otherwise the older PSU may not turn on.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Black Box Corporation
Black Box Corporation CAT6 EZ-RJ45 Modular Plugs 100-Pack
$95.99
0.0011497BTC
In stock
