TeKit
TeKit DMS-59 Male to 2 VGA Female Y Splitter Cable .5 ft
Splits a DMS-59 video output to two VGA monitors using a shielded .5 ft copper cable with 59-pin male and dual 15-pin female connectors
- TypeDMS-59 Pin to 2 Dual VGA 15Pin Female Splitter Adapter Cable
- ColorBlack
- Length< 1"
- Connector Number3
- Connector DetailDMS-59 Pin to 2 Dual VGA 15Pin Female Splitter Adapter Cable
- Terminal GenderDMS-59 Pin to 2 Dual VGA 15Pin Female Splitter Adapter Cable
- Split one DMS-59 output to two VGA monitors
- 5 ft cable keeps dual-display setups tidy
- Copper conductors and foil shielding reduce signal interference
- 59-pin male to dual 15-pin female connectors fit standard video cards
- Compatible with Dell, Sony, Compaq, HP, Gateway and other brands
DMS-59 Male to Dual VGA Female Adapter
This splitter cable connects a single DMS-59 male port on a video card to two 15-pin VGA female connectors. It enables dual-monitor output from one graphics output without requiring an additional card. The 0.5 ft length keeps the cabling short and tidy inside compact chassis. It is aimed at IT staff and builders deploying multi-display workstations on hardware with DMS-59 outputs.
Foil-Shielded Copper Conductor Build
The cable uses copper conductors wrapped in foil shielding to reduce EMI and RFI interference during analog signal transmission. Three connectors — one DMS-59 male and two VGA female — are moulded in black with thumbscrew retention on the DMS-59 side. The Y-splitter format means both monitors attach directly to the pigtail, eliminating the need for a separate breakout box or bracket.
Replaces Bulky Breakout Brackets
This adapter replaces full-size DMS-59 breakout brackets that occupy a slot bracket and require extra cabling. The short pigtail suits low-profile cards and small-form-factor systems where bracket clearance is limited. It is not suited for installations needing longer runs between the card and the monitors, nor for digital-only DVI or DisplayPort outputs.
Highlights
- Split one DMS-59 output to two VGA monitors
- 5 ft cable keeps dual-display setups tidy
- Copper conductors and foil shielding reduce signal interference
- 59-pin male to dual 15-pin female connectors fit standard video cards
- Compatible with Dell, Sony, Compaq, HP, Gateway and other brands
Specifications
| Brand | Tekit |
|---|---|
| Type | DMS-59 Pin to 2 Dual VGA 15Pin Female Splitter Adapter Cable |
| Color | Black |
| Length | < 1" |
| Connector Number | 3 |
| Connector Detail | DMS-59 Pin to 2 Dual VGA 15Pin Female Splitter Adapter Cable |
| Terminal Gender | DMS-59 Pin to 2 Dual VGA 15Pin Female Splitter Adapter Cable |
| Specifications | DMS-59 Pin to 2 Dual VGA 15Pin Female Splitter Adapter Cable |
| Connect From | 1X DMS-59 Pin Male |
| Connect To | 2X VGA Female |
| Shielding | Yes |
| Conductor | Copper Conductor |
| Features | DMS-59 Pin to 2 Dual VGA 15Pin Female Splitter Adapter Cable |
| Cable Length | 0.5 ft. |
Questions about this item
What resolution does the DMS-59 interface actually support when split to two VGA monitors?
The DMS-59 connector carries two independent VGA analog channels so each 15-pin output can drive its own monitor at the card's maximum VGA resolution.
How much clearance does the .5 ft cable need behind a low-profile bracket?
The splitter body sits directly on the card bracket; only the two VGA cables extend, so allow roughly the length of a standard VGA plug plus cable bend radius.
Which end plugs in first when installing this Y splitter on a live system?
Seat the DMS-59 male connector onto the video card until the thumbscrews engage, then attach each VGA cable to its monitor.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Black Box Corporation
Black Box Corporation CAT6 EZ-RJ45 Modular Plugs 100-Pack
$95.99
0.00115589BTC
In stock
