We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Five black OBD2 Y-splitter cables with 16-pin connectors, 30cm length

TAURKENAM

TAURKENAM Underdash OBD2 Splitter Y Cable 5pcs 30cm

SKU CH-XVYC-NF4A4

Pack of five 30 cm OBD2 Y-cables with full 16-pin wiring for simultaneous dual-device use

  • Typetype
  • Five cables per pack for multiple installations
  • All 16 pins fully connected for complete data access
  • Y splitter runs two devices simultaneously from one port
  • 30 cm length suits under-dash routing
  • New condition ready for immediate use

Five-Pack OBD2 Y-Splitter Cables

Each pack supplies five splitter cables so multiple tools can share a single vehicle diagnostic port. Workshops and fleet operators can equip several bays or technicians without sourcing individual adapters. The set suits anyone needing simultaneous access for a scanner and a logger or two scan tools. Buyers who need only a single splitter will find the five-pack excessive.

16-Pin Full Connection With Dual Device Support

All sixteen pins are wired through each splitter so every signal the port provides reaches both connected devices. The cables allow two OBD2 devices to operate at the same time from one socket. Headroom ends when a third device is required or when a tool demands a proprietary pin arrangement not covered by the standard layout.

30cm Length For Tight Underdash Routing

A 30cm cable keeps the Y-junction close to the port, reducing clutter under the dashboard and avoiding snagging on pedals or trim. The short reach suits permanent installs where a GPS tracker and a diagnostic dongle share the socket. Installers needing a longer tail to reach a glovebox or centre console must source extension cables separately.

Highlights

  • Five cables per pack for multiple installations
  • All 16 pins fully connected for complete data access
  • Y splitter runs two devices simultaneously from one port
  • 30 cm length suits under-dash routing
  • New condition ready for immediate use

Specifications

Typetype

Questions about this item

Will the TAURKENAM OBD2 splitter's 16-pin connection work with my older scan tool that uses the same port?

Yes, the splitter's 16-pin fully connected pin-out matches the standard OBD2 port, allowing your existing scan tool to communicate while a second device is also plugged in.

How can I verify the 30cm TAURKENAM Y cable is functioning correctly after I plug it in?

Connect two devices simultaneously; both should power on and read live data from the vehicle ECU without errors, confirming all 16 pins are active.

Does the 5-pack of TAURKENAM splitter cables include any mounting hardware or adapters?

The box contains only the five 30cm Y-cable splitters; no mounting brackets, Velcro strips, or additional adapters are supplied.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.